AXTON A580DSP Installatie- en bedieningshandleiding - Pagina 3

Blader online of download pdf Installatie- en bedieningshandleiding voor {categorie_naam} AXTON A580DSP. AXTON A580DSP 15 pagina's. 4-channel smart digital amplifier

Pagina afdrukken

TECHNICAL SPECIFICATIONS

Music Power Output:

150 W x 4 (110 W x 4*)

RMS Power Output:

76 W x 4 (56 W x 4*)

Frequency response:

20Hz ~ 20 kHz

Audio sampling frequency:

192 kHz

Distortion:

1 KHz <0.001%

Supply voltage range:

9V - 15V

Signal to noise ratio:

> 120 dB

Dynamic range:

> 100 dB

Standby current:

< 0.4 mA

Maximum operating current:

20 A

Dimensions (LxWxH):

185(206) x 114 x 40 mm

*without additional power supply

MAIN FEATURES

4-channel Smart Digital Amplifi er with iOS or Android App controlled audio DSP

functions

DSP-controlled 5-channel Preout (6 Volt) including REM-Out to control additional

amplifi ers

Plug'N'Play quick installation system via optional vehicle brand and model specifi c

ISO wire harness

Auto-Turn-On function

FUNCTIONALITY & ADJUSTABILITY

Bluetooth connection and control of DSP settings via iOS or Android Smartphone App

Freely confi gurable 3-way active crossover: High-/Low-/Band-/Bypass with

6/12/18/24dB/Oct. slope

Time Alignment in cm (0 – 230 cm) for front, rear and subwoofer channel

5 channel control: Gain, Phase switch and Mute function for each speaker

Freely confi gurable 7-band parametric Equalizer for front, rear and 4 speaker

Can save 5 memories in the amp and unlimited sound settings on the smartphone

Dynamic Bass setting for powerful performance without subwoofer

3D surround sound

– 4 –

INSTALLATION DIAGRAM

MOUNTING INSTRUCTIONS

1. Before you start with the installation, make sure you know the security code of your

headunit (if applicable).

2. Remove the headunit from the dashboard and disconnect the main wire.

3. Find a place for the A580DSP and connect the provided (or optionally available

car-specifi c) wire to the amp.

4. For more power output please follow these steps: Run a 10 mm

the (+) pole of the battery to the (BATT) terminal of the amplifi er. Use a fuse with the

related value of the cross section of the power wire. The distance between the B+

pole and the fuse holder must be 30 cm or less. Run the minus cable with the same

cross section from the (GND) terminal of the amp to the vehicle chassis ground.

Make sure that the contact surface is clean in order to get best conductance.

5. Make sure the switch "DSP" is set to "ON".

6. Connect the wire to the headunit.

7. Install the headunit back in the dashboard.

ORIGINAL CAR SOCKETS

HEAD UNIT

power wire from

– 5 –