Circe Cycles Helios Gebruikershandleiding - Pagina 7

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Circe Cycles Helios. Circe Cycles Helios 12 pagina's. Separable tandem
Ook voor Circe Cycles Helios: Montagehandleiding (8 pagina's), Gebruikershandleiding (15 pagina's)

Circe Cycles Helios Gebruikershandleiding

2.12 Assembly

Step 1.
Remove all the parts from the case taking care not to
damage any of the parts in the process. Start by
sliding the drain pipe on to the rear section, pushing
on as far as the end of the matt section. Leave the
pinch bolts loose for the moment. If the bike has a
stand fitted, use it to support the rear end.
N.B. Ensure you have the drain pipe the correct way
round, with the chain tensioner on the drive side.
Step 3
Fit the Captain's handlebars on to the stem and fit
back onto the bike (make sure the Q/R is tightened
fully). Insert the Stoker seatpost into the bike and
extend enough to stand the bike upside down. Using
the change tensioner align the drainpipe with the
stoker and captain chainsets. Once aligned tighten the
pinch bolts to recommended torque setting (17 Nm).
N.B. When tightening the pinch bolts it is advisable to
alternate between each bolt in a pair, so that they are
tightend together, this ensures correct
tension.
Step 2
Slide the front section into the drain pipe pushing it
up to the end of the matt section. Then align the front
and rear section, so that the stoker cross bar can be
fitted. To ensure correct engagement of the
couplers the position of the front or rear section may
need to be adjusted in the drain pipe until the
couplers fit together correctly. Insert the bolts into the
couplers and with a 6 mm allen key tighten them to
the recommended torque setting (17 Nm).
N.B. Note cable orientation before fixing the stoker
cross bar in place.
Page 6