Arcan A20018 Handmatig - Pagina 2

Blader online of download pdf Handmatig voor {categorie_naam} Arcan A20018. Arcan A20018 6 pagina's. 3 ton aluminum floor jack

Pagina afdrukken

INSPECTION

Visual inspection should be made before each use of the jack, checking for leaking hydraulic fluid and damaged, loose or missing

parts. Any jack which appears to be damaged in any way, is found to be badly worn, or operates abnormally MUST BE REMOVED

FROM SERVICE until necessary repairs are made.

Handle

Saddle

Front

Wheels

SETUP (Refer to page 5 to identify reference numbers)

1. Depress the spring button at the bottom of the (62) handle half and insert it in the (60) lower handle half until the spring button

engages the hole in the lower handle half.

2. Remove the (54) handle set screw from the (55) handle yoke. Install the assembled handle into the (55) handle yoke making sure

the bottom of the handle engages the release valve u-joint.

3. Install the (54) handle set screw in the (55) handle yoke and tighten the screw to secure the handle in the yoke.

IMPORTANT: In most cases the jack should work normally right out of the box but it is not unusual for air to get trapped in the jack's

hydraulic system during shipping and handling. There are several symptoms of an air trapped hydraulic system which include only partial

incremental pump stroke, jack will not lift load, jack will not sustain load or pumping feels spongy under load. The following procedure

will purge air from the hydraulic system and only needs to be done if experiencing the above mentioned conditions.

a) The (36) saddle should be in its lowest position. Remove the oil filler plug in the reservoir of the (50) hydraulic power unit.

b) Look inside the oil fill plug hole. You should be able to see the top of the power unit's cylinder. The hydraulic fluid level should

be no higher than the top of the cylinder. Correct the fluid level if it is not at the proper height. CAUTION: In order to prevent seal

damage and jack failure, never use alcohol, hydraulic brake fluid, or transmission oil in the jack. Use hydraulic jack oil, a light

turbine oil, Chevron Hydraulic Oil AW ISO 32 or Unocal Unax AW 150.

A20018 User Manual

Handle

Socket

Handle Socket

Bolt

Lift Arm

Handle

Chassis

Upper

Handle

Lower Handle

Handle

Bumper

Handle

Socket

Rear

Casters

Upper

Handle

Lock

Lower

Handle

Bumper

02/07/2020