Axxera AXA40D Installatie- en gebruikershandleiding - Pagina 3

Blader online of download pdf Installatie- en gebruikershandleiding voor {categorie_naam} Axxera AXA40D. Axxera AXA40D 13 pagina's. Axa series mobile power amplifiers

Pagina afdrukken

Connection Descriptions

NOTE:

Be sure to follow specific instructions included with your amplifier installation

kit (not included with this amplifier). The information below should be used as a

general guideline only.

Power Wire (+12V)

• D isconnect negative battery terminal before proceeding. Consult a qualified

technician for instructions if you are unsure.

• P lan wire routing before cutting any wires to length. Begin by routing the power

+12V wire from the battery to the amplifier location. Use a grommet when running

wires through the firewall or metal openings. Avoid running the power wire near

existing vehicle wiring to prevent induced noise from entering the audio system.

• U se extreme caution when drilling holes to avoid damaging fuel lines or existing

vehicle wiring.

• T he +12V wire MUST be fused within 18" of the battery for protection of the vehicle's

electrical system.

Ground Wire (GND)

• T he amplifier ground wire should be as short as possible. Choose a clean unpainted

section of metal or the vehicle chassis when attaching the ground connection. Be

sure to clean the area of any dirt or grease.

Remote Turn-on Wire (REM)

• T he remote turn-on wire connects to the head unit's amplifier turn-on lead or power

antenna output.

Speaker Wires

• C hoose adequate gauge speaker wire depending on your exact amplifier/speaker

combination. Be sure to observe polarity when connecting.

• D o not ground any speaker wires or connect any speaker wires together.

Input Signal

• T he amplifier's input signal connects to the head unit's low level (RCA) or high level

(speaker wire) outputs.

• L ow level input signals deliver the best performance. If unavailable, use the high level

inputs - when interfacing with factory head unit for instance.

CAUTION

• D o not use both low and high level inputs at the same time - connect only one or the

other.

• N ever run any wires underneath or outside the vehicle.

INSTALLATION