Axxess ASWC-TOY-LEX Handleiding voor installatie-instructies - Pagina 4
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Axxess ASWC-TOY-LEX. Axxess ASWC-TOY-LEX 8 pagina's. Steering wheel control interface for select toyota and lexus vehicles
Pagina afdrukken
INSTALLATION INSTRUCTIONS FOR PART ASWC-TOY-LEX
1st LED flash is for Eclipse (type 1)
2nd LED flash is for Kenwood
3rd LED flash is for Clarion (type 1)
4th LED flash is for Sony and Dual
5th LED flash is for JVC
*Note: If the ASWC-1 flashes 7 times and you do not have an Alpine radio connected to it that means that the
ASWC-1 did not see any radio connected. Verify the 3.5mm connector is connected to the steering wheel control
input into the radio.
**Note: The AX-SWC-PARROT is required (sold separately). The radio must be updated to rev. 2.1.4 or higher from
www.parrot.com and ASWC-1 must be updated to the latest firmware from www.axxessinterfaces.com.
Resetting the SWC buttons
Resetting the SWC Buttons back to default
1) Turn the ignition on, and wait three seconds.
2) Press the reset button for three seconds, then let go.
3) Once flashing fast, wait until the LED on the ASWC-TOY-LEX goes solid (about twenty seconds).
Note: • Do not press any buttons on the steering wheel or radio during this time.
• If the ASWC-TOY-LEX does not flash fast the Reset button was not depressed properly.
4) Once solid, the ASWC-TOY-LEX is reset and should be working with default settings.
METRA. The World's best kits.
Radio legend
6th LED flash is for Pioneer & Jensen
7th LED flash is for Alpine*
8th LED flash is for Visteon
9th LED flash is for Valor
10th LED flash is for Clarion (type 2)
1-800-221-0932
™
11th LED flash is for Metra OE
12th LED flash is for Eclipse (type 2)
13th LED flash is for LG
14th LED flash is for PARROT
15th LED flash is for XITE
metraonline.com
IMPORTANT WARNING
This product includes instructions for installation which
must be carefully followed. The instructions are worded
in such a manner to assume that the installer is capable
of completing these type of electronic installations. If
you are unclear as to what you are instructed to do
or believe that you do not understand the instructions
so as to properly and safely complete the installation
you should consult a technician who does have this
knowledge and understanding.
Failure to follow these instructions carefully and to
install the interface as described could cause harm
to the vehicle or to safety systems on the vehicle.
Interference with certain safety systems could
cause harm to persons as well. If you have any
questions in this regard please call the Help line or
Metra at 1-800-221-0932 for assistance.
K
NOWLEDGE IS
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
© COPYRIGHT 2004-2013 METRA ELECTRONICS CORPORATION
P
OWER