CIRCUIT DESIGN STD-302 Bedieningshandleiding - Pagina 11

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} CIRCUIT DESIGN STD-302. CIRCUIT DESIGN STD-302 20 pagina's. Uhf narrow band radio transceiver 429 mhz
Ook voor CIRCUIT DESIGN STD-302: Bedieningshandleiding (16 pagina's)

Pagina afdrukken

PLL IC CONTROL

PLL IC control
Voltage Controled
Reference Oscillator
STD-302S is equipped with an internal PLL frequency synthesizer as shown in Figure 1. The operation of the PLL
circuit enables the VCO to oscillate at a stable frequency. Transmission frequency is set externally by the
controlling IC. STD-302S has control terminals (CLK, LE, DATA) for the PLL IC and the setting data is sent to the
internal register serially via the data line. Also STD-302S has a Lock Detect (LD) terminal that shows the lock
status of the frequency. These signal lines are connected directly to the PLL IC through a 2 kΩ resistor.
The interface voltage of STD-302S is 2.8 V, so the control voltage must be the same.
STD-302S comes equipped with a Fujitsu MB15E03SL PLL IC. Please refer to the manual of the PLL IC.
The following is a supplementary description related to operation with STD-302S. In this description, the same
names and terminology as in the PLL IC manual are used, so please read the manual beforehand.
OG_STD-302S-429M_v11e
up to 1200MHz
VCO
Oscillator
LPF
+2.8v
21.25MHz
Figure 1
Fin
CLK
Xf in
Data
GND
LE
PLL
Do
PS
MB15E03SL
VCC
ZC
Vp
LD/f out
OSCout
P
OSCin
R
11
OPERATION GUIDE
2kohm
CLK
2kohm
DATA
2kohm
LE
2kohm
LD
STD-302
Control pin name
#:Control v oltage = +2.8v
Circuit Design, Inc.
.