CIRCUIT DESIGN MU1-UIK Bedieningshandleiding - Pagina 12
Blader online of download pdf Bedieningshandleiding voor {categorie_naam} CIRCUIT DESIGN MU1-UIK. CIRCUIT DESIGN MU1-UIK 17 pagina's. Embedded low power radio modem mu-1/mu-1 usb interface kit
Pagina afdrukken3.2 The USB Driver
3.2.1 Installing the USB Driver
The MU1-USB supports Windows plug and play. Connect the double shield USB cable (USB 2.0 High Speed) to the
unit, then connect the cable to the computer. The install USB driver window opens automatically. Follow the
instructions to install the driver. The MU1-USB driver file is located in the setup disk [USB_Driver] folder.
3.2.2 Uninstalling the USB Driver
To uninstall the driver, use the "Add/Remove Programs" Control Panel.
Be sure to disconnect the MU1-USB from the computer first.
If you uninstall the driver with the MU1-USB connected the computer, the Windows registry will
Caution
not be deleted normally. This may result in problems when you next install the driver.
3.2.3 Checking that the USB Driver Works
To check that the USB driver works, use the Windows Control Panel > System > Device Manager. Check that
MU1-USB appears in the Properties.
3.3 Initializing
Initialize the unit to the factory default settings if communication with the MU-1 mounted on the MU1-USB is not
possible or if you are uncertain of the internal settings.
How to initialize the MU-1
Turn on the power while pressing the initialize switch. Then turn the power off and on once again to reset the unit to
the default settings. For details, refer to the default values for each command in the MU-1 Operation Guide.
Status after resetting
The values of the main parameters after initializing are as follows.
1. Link related parameters
User ID: UI = 0000, Group ID: GI = 00, Equipment ID: EI = 01, Destination ID: DI = 01, Channel = 0 channel
2. UART related parameters
Baud rate = 19,200 bps, parity = none, stop bit = 1
3. Parameters related to internal operation
Mode = command
OG_MU1-UIK_v20e
11
OPERATION GUIDE
Circuit Design, Inc.