Arcflash Labs EMG-01 Beta Gebruikershandleiding - Pagina 6
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Arcflash Labs EMG-01 Beta. Arcflash Labs EMG-01 Beta 16 pagina's. 8 stage igbt coilgun
Pagina afdrukken
accidental discharge include broken bones and severe injuries – in short, never point the device
at anything you don't want to destroy. Treat it as loaded at all times.
The device operates on low voltage (25V), but carries extremely high amperage (300A+)
during a shot, which is immediately converted to high voltage (300V+) in the driver coils. While
most of the components experiencing transient high voltage spikes are protected from the
user, it is advised that you should never touch any internal components of the gun during a
shot, especially those near the barrel. 300V is more than enough to cause serious electrical
shock, personal injury or death.
2.2 Electronics Bay
- Never stick any object or any part of your body into the Electronics Bay
- Do not touch the Discharge Current Limiter (DCL) after powering down the gun- it may
become hot enough to cause burns.
- Do not stick any object or any part of your body in between the injector solenoid and
the barrel
- Always take care to INSPECT THE ELECTRONICS BAY after removing the magazine. Loose
rounds could cause a short which could damage the gun.
- Take care to protect the exposed components (ICL, firing mode switch and main switch)
from excessive force. Never rest the gun in a position where these switches are stressed.
- Always store the gun in a safe place where the switches are protected. Damage to these
components will result in permanent damage to the gun
The "Electronics Bay" is a large cavity in the EMG-01B above the trigger and magazine
socket housing a number of critical components. The most important of which components
are: the injector solenoid, the Discharge Current Limiter (DCL), the fuse (and fuse socket), the
main switch, and the firing mode selector.
It is important to keep this cavity clear of debris at all times and to protect all
components in this area from water, dust and contamination. It is due to the fragility of the
components in the Electronics Bay that this EMG-01 model is still considered a "Beta Testing"
version as this area is still vulnerable to damage if care is not taken to protect it.
Projectiles are pushed out of the magazine by a pulsed solenoid, known as the injector.
This injector has a spring loaded mechanism which allows it to return to its home position. It is
this spring return mechanism which sets the maximum rate of fire of the gun. 8 rounds per
second is the maximum safe rate of fire of the injector, and hence the maximum rate of fire of
the EMG-01B.
The ICL is a large resistor which converts the stored energy in the capacitors to heat
when the gun is powered down. This allows the gun to be powered down quickly when the
6 |
P a g e