Aybey Elektronik CLP Handleiding voor programmering en installatie - Pagina 3

Blader online of download pdf Handleiding voor programmering en installatie voor {categorie_naam} Aybey Elektronik CLP. Aybey Elektronik CLP 5 pagina's. Custom design lcd display board

Pagina afdrukken

PROGRAMMING

On board, there are 3 buttons named as INC (↑), DEC (↓) and ENT. ENT button is used to enter and

exit to/from programming mode, to approve and to save settings. INC (↑) and DEC (↓) buttons are

used to increase and decrease current value and move up and down in menu.

FLOOR DISPLAY SETTINGS (Only in CLP)

Push and hold ENT button a few second to enter programming mode where arrows and busy icon

always blink to distinguish it from normal mode. Floor number blinks and firstly change floor number

with INC (↑) and DEC (↓) buttons to set. Then with ENT button, right display, left display, display

color and signals colors can be select and set with INC (↑) and DEC (↓) buttons respectively.

This display shows upper menu of Floor 0 (bottom floor). To edit Floor 0 display data, push ENT

shortly and enter sub-menu.

Here right char blinks. Now it can be changed by pushing INC (↑) and DEC (↓) buttons. Any number

or letter can be chosen. After selecting right char, push ENT shortly and left char starts to blink. In the

same way left char is set. Then select floor and signal color by pushing ENT and change with INC (↑)

and DEC (↓) buttons. If no color selected to signals, then floor color displays.

After setting displays, push and hold ENT button for a few seconds, then all setting are saved into

permanent memory. At any step of programming it is possible to save changes and exit in the same

way. Now display turns to normal mode and shows current floor info.

SET AS A SINGLE COLOR TO ALL FLOORS

If single color is desired in all floors and signals, then set floor 0 to desired color and push and hold

ENT and DEC (↓) buttons both to save settings to permanent memory.

F/7.5.5.02.87 R:2

CLC / CLP