Epson DFX-5000+ Handmatig - Pagina 6

Blader online of download pdf Handmatig voor {categorie_naam} Epson DFX-5000+. Epson DFX-5000+ 8 pagina's. Product support bulletin(s)
Ook voor Epson DFX-5000+: Brochure & specificaties (24 pagina's), Product ondersteunings bulletin (20 pagina's), Product ondersteunings bulletin (3 pagina's), Productinformatie (5 pagina's), Product ondersteunings bulletin (5 pagina's), Product ondersteunings bulletin (3 pagina's), Product ondersteunings bulletin (20 pagina's), Product ondersteunings bulletin (14 pagina's), Product ondersteunings bulletin (25 pagina's), Product ondersteunings bulletin (16 pagina's), Product ondersteunings bulletin (8 pagina's), Product ondersteunings bulletin (2 pagina's)

Pagina afdrukken
Epson DFX-5000+ Handmatig
(3621ý');ðèíííò
6. Open both sprocket covers.
7. Be sure the paper has a clean, straight edge, and then fit the
first five holes in the paper over the pins of the sprocket
units as shown below. The side of the paper that you want
to print should be facing you. Now close the sprocket
covers.
8. Slide the right sprocket unit so that the paper is straight
and has no wrinkles. Lock the sprocket unit in place by
pushing the sprocket lock lever up.
9. Pull out slightly on the printer's front cover and lower it
until it is closed.
10.Turn on the printer.
11.Press the LF/FF/LOAD button. If the paper does not load,
the front tractor may not be selected. Press the
FRONT/REAR button to select the front tractor.
Running the self-test
Before running the self-test, turn off the printer if it is on.
Wait 10 seconds before starting the self-test.
The self-test can be run in either draft or near letter quality
(NLQ) mode.
1. While holding down the LF/FF button (for draft mode) or
the TEAR OFF button (for NLQ mode), turn on the printer.
After printing starts, release the button.
The printer prints a series of characters.
(3621ý');ðèíííòýðýç
2. The self-test continues until the paper runs out or until you
press the PAUSE button. (To resume the test, press the
PAUSE button again.)
3. To end the self-test, press the PAUSE button to stop printing
and then hold down the LF/FF button to advance the
paper.
4. Open the paper separator cover and tear off the paper at
the perforation.
5. Turn off the printer.
,QVWDOODWLRQî6XSSRUWý7LSV

Physical installation

The DFX-5000+ printer is very easy to set up, but because it is
a very high-speed machine, take special care to ensure that a
proper paper path is established. EPSON printer stand model
8502 is specially designed to accommodate the printer, and
its use is recommended but not required. This stand provides
a catch bin and a paper supply shelf large enough to hold
paper for both the front and rear tractors, as well as detents,
which hold the printer securely in place.
If this stand is not used, make sure that the paper supply to
both tractors is properly aligned (no skewing to either side)
and that the paper exiting does not interfere with the rear
paper supply. Also ensure that the power and interface
cables are routed away from both incoming and exiting
paper.
The following illustration shows three ways to position the
printer and paper supply: with the front tractor loaded, with
the rear tractor loaded, and with both tractors loaded.
êîìèîäé