Digiflex SMART RF RF120 Installatiehandleiding - Pagina 2

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Digiflex SMART RF RF120. Digiflex SMART RF RF120 8 pagina's. Base station with relay outputs

Pagina afdrukken

RF120-RF121-SMART RF Base Stations - RS485

The SMART RF Base Station is an advanced 2-Way

433Mhz transceiver that interfaces directly to compat-

ible control panels via an RS485 LAN connection. There

are two built in radio transmitters and receivers with

dual diversity internal antennas. Indicator lights display

the status at all times while front and rear tampers pro-

tect against unauthorised access.

Multiple receivers can be installed on a single LAN creat-

ing a network of access points where RF devices can

communicate across larger areas.

Base Station Receiver Compatibility

RF120

Vision-X

Solution 6000

RF121

Vision-X

Solution 6000

Table 1: Compatibility

The 2-way communication is encrypted with rolling

code and anti substitution technology making the

SMART RF base station an ideal choice for your wireless

security system.

Receiver Addressing

Each receiver fitted to the system must be assigned a

unique address on the LAN. Both models includes a DIP

switch for quick address selection. The following table

shows the address setting for each receiver as well as the

number of receivers each panels can support.

Base Station Receiver Address Setting

Address S1

OFF OFF OFF OFF

ON OFF OFF OFF

OFF ON OFF OFF

ON ON OFF OFF

Table 2: Receiver Address

Only 1 receiver can be assigned to each address.

All receivers are supplied from the factory set to

Note

address 1. You must power cycle the panel or

perform a LAN scan whenever you change the ad-

dress. Currently only 4 receivers are supported.

DIP Switch 5 - LAN Termination

LAN Termination if required can be enabled by

placing switch 5 in the ON position.

Page

P/N: RF120-RF121IRG Rev 1.30



Version

Receivers Supported

2.30

Version

Receivers Supported

2.52

2.51.04

2 3 4 5

Figure 1: Receiver Address Switch

Tamper Switch Operation

In your installation one or both of the case tamper

switches may not be needed. Setting switch 1 to the ON

position will disable the rear case tamper and switch 2 in

the ON position will disable the front cover tamper. From

the factory both tampers are enabled. The housing must

be correctly installed for the rear tamper to function cor-

rectly.

Switch 1 ON = Disable Rear Tamper

Switch 2 ON = Disable Front Tamper

Figure 2: Tamper Switch Control

Box Contents

The box contains the following parts.

RF Base Station Receiver PWA

Case (Front & Back) + LED Light Pipe + Cam Lock

Instruction Sheet

Bosch RF Device Compatibility

The RF120 Base Station is capable of supporting selected

Bosch RF peripherals like PIR's, Reed Switches and Shock

Sensors etc. You must enable Bosch compatibility mode

in panel programming, MENU 6-2-0, Option 8 to enable

this feature.

For best performance, if you are not using Bosch RF

peripherals then you should leave this option disabled.

Mounting Considerations:

•

Mount the receiver in a location that is central rela-

tive to where the wireless devices will be mounted.

•

Mount on a vertical surface with at least 30 cm clear-

ance from other objects as the antennas are internal.

•

Avoid mounting the receiver in areas with significant

metal or electrical wiring.

•

Avoid mounting the receiver in areas where it may

be exposed to moisture or high humidity.

•

Reception distances are generally improved with

higher mounting locations and with no metal ob-

jects near the unit.

•

If range is not achievable due to environmental or

specification limitations then add additional receiv-

E&OE