CREE LIGHTING CONNECTED MAX Installatie-instructies - Pagina 3

Blader online of download pdf Installatie-instructies voor {categorie_naam} CREE LIGHTING CONNECTED MAX. CREE LIGHTING CONNECTED MAX 3 pagina's. Smart indoor camera
Ook voor CREE LIGHTING CONNECTED MAX: Snelstarthandleiding (14 pagina's), Snelstarthandleiding (10 pagina's)

Pagina afdrukken

CREE LIGHTING CONNECTED MAX Installatie-instructies

Dimmer Troubleshooting

Issue

Press any button, Dimmer LED

indicator does not blink

Replaced existing switch and

fixtures will not turn on

Dimmer will not control fixtures

FCC NOTICE

This device complies with Part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) this device may not

cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause

undesired operation. Any changes or modifications not expressly

approved by the party responsible for compliance could void the

user's authority to operate the device.

This device has been tested and found to comply with the limits

for a Class A digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference when the device is operated in a commercial

environment. This device generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with

the instruction manual, may cause harmful interference to radio

communications. Operation of this device in a residential area is

likely to cause harmful interference in which case the user will be

required to correct the interference at his own expense.

In addition, this device complies with ICES-003 of the Industry

Canada (IC) Regulations.

is subject to change. See www.creelighting.com/warranty for warranty and specifications. Cree

registered trademarks and the Cree SmartCast Technology logo is a trademark of Cree, Inc. SmartCast

trademark of Cree Lighting, A company of IDEAL INDUSTRIES.

3 of 3

Resolution

Check wiring

(LINE/NEUT/GND required)

Press & hold on the ON button and the LED

indicator will flash fast continuously to enter it

into the pairing process.

Check Wiring (each fixture shall be wired with

constant HOT)

Check group assignments with Configuration

Tool

INDUSTRY CANADA STATEMENT

This device complies with Industry Canada licence-exempt RSS

standard(s). Operation is subject to the following two conditions: (1)

this device may not cause interference, and (2) this device must accept

any interference, including interference that may cause undesired

operation of the device. In addition, this device complies with ICES-003

of the Industry Canada (IC) Regulations.

Le présent appareil est conforme aux CNR d'Industrie Canada

applicables aux appareils radio exempts de licence. L'exploitation est

autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas

produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter

tout brouillage radioélectrique subi, même si le brouillage est

susceptible d'en compromettre le fonctionnement.

and the Cree logo are

, is a registered

www.creelighting.com

LPN00838X0003A0_A