Creek Audio 5250SE Gebruiksaanwijzing - Pagina 3
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Creek Audio 5250SE. Creek Audio 5250SE 4 pagina's.
Ook voor Creek Audio 5250SE: Gebruiksaanwijzing (2 pagina's)
Pagina afdrukken
VOLUME LEVEL
The volume control, situated on the right hand side of the front panel, is used to alter the relative
level of the sound output from the amplifier. The volume control is necessary to adjust the level from
one piece of equipment to another. It does not increase the power of the amplifier and if it is found
necessary to have the volume control set to a position which is considered to be high, before the
desired level of volume is obtained, it does not necessarily mean that the amplifier is having to work
"flat-out". If more sensitivity is required, you may need to install a line stage pre-amp.
OPERATING THE 5250
Make sure that the unit is on a suitable table, shelf or Hi-Fi equipment cabinet. It is important to
allow adequate ventilation to the heatsink in the centre of the unit. Avoid obstruction of the ven-
tilation slots on the top and bottom of the amplifier. It may be necessary to place the amplifier on the
top of other equipment to allow for this.
Always have the volume control set at minimum (counter-clockwise) when switching on and off, to
avoid any sudden loud noises. Select the desired input on the rotary selector and switch on the
amplifier with the push button marked Power on the right hand side of the front panel. Adjust the
volume gently and settle down to listen.
Your 5250 amplifier is designed to give you years of reliable use. If you need more assistance, it is
always advisable to go back to the supplying dealer for his expert help. If you are unfortunate
enough to need service work to be carried out on your amplifier, it should be returned to your dealer
in the original packing material if possible.
REMOTE CONTROLLED VERSION (5250R & 5250SE)
The 5250R and 5250SE front panel controls function in exactly the same way as the standard 5250.
The Creek Amplifier Remote Control handset allows the user to operate the volume control, input
selection and mute by an infra-red (RC5) link. The bottom three buttons on the handset are for
motorised volume up + down, plus mute functions. The buttons marked 1 Phono to 6 Tape are for
selecting the desired source via a motorised version of the rotary input selector. Handset buttons 7,
8, 9 & 0 are not used on the 5250.
When the 5250R or the 5250SE are first switched on, the power LED will glow yellow until the
protection circuit confirms everything is OK. The LED will then turn green and, if selected, the
loudspeaker relays will click on. Volume changes will cause the Power LED to flash green. Pressing
the mute button will cause the LED to turn yellow. Pressing the button again or increasing the
volume will un-mute the amp and the LED will turn green again. Adjusting the volume downwards by
remote will not un-mute the amp. Please note, muting can only be cleared by the remote handset or
by pressing the amplifier power switch off for 10 seconds and on again. If the amplifier stops
working and the Power LED turns red, it indicates a fault. Return the amplifier to the supplying
dealer for inspection.
H.B. The 5250 is designed to work properly in normal domestic operating conditions. However, the
amplifier's performance may be seriously affected if sited near to, or in the room with, a radio
transmitter such as a mobile phone or CB radio rig, etc. Re-siting the 5250 or the radio will
normalise the situation.