Creek Company ODC SUPERSPORT XR 1 Montage-instructies - Pagina 4

Blader online of download pdf Montage-instructies voor {categorie_naam} Creek Company ODC SUPERSPORT XR 1. Creek Company ODC SUPERSPORT XR 1 4 pagina's.

Pagina afdrukken

Your ODC Outdoor Discovery Craft

Please follow inflation instructions and warnings carefully.

IF YOU EVER HAVE ANY QUESTIONS OR PROBLEMS WITH YOUR ODC SUPERSPORT XR 1

RETURN IT TO THE DEALER YOU BOUGHT IT FROM. PLEASE CONTACT THE CREEK COMPANY

DIRECTLY AT 970-879-5221. WE ARE OPEN M-F 9AM-5PM MOUNTAIN TIME. OR CONTACT US VIA E-MAIL AT

[email protected].

HIN is located on square tubing of seat support frame member and on right main frame member (See Figure 1)

Your Creek Company SUPERSPORT XR1

product to the original owner. This does not cover damage due to misuse or normal wear and tear.

Please read and follow carefully.

1. Always wear a US Coast Guard approved personal flotation device when in your ODC SUPERSPORT XR 1

2. Never float alone.

3. Always check your ODC SUPERSPORT XR 1

damage before you use your craft.

4. Never use your craft if you suspect the Air Bladders, outer skin or stitching has been damaged.

5. Never overinflate your ODC SUPERSPORT XR 1

6. Never use your ODC SUPERSPORT XR 1

7. Your ODC SUPERSPORT XR1

1. If your Pontoon Bladder is losing air, please check that Valve Assembly and Top Valve Cap are fully seated. Reseat valve assembly

and repeat pontoon inflation instructions.

2. Do not store your ODC SUPERSPORT XR 1

3. If you are leaving your ODC SUPERSPORT XR 1

pressure inside the Pontoons to a dangerous level. Let some of the air out of the pontoons if the craft will be out of the water in

the sun for any length of time, or if it is stored in a vehicle, etc.

4. A gain in altitude will increase the pressure in the Pontoons also. If you are taking your inflated ODC SUPERSPORT XR 1

from a low elevation to a high elevation, be sure to let some of the air out of it.

5. For short term storage, we recommend you let some air out of your pontoons.

6. For long term storage, we recommend you make sure your ODC SUPERSPORT XR 1

out of the sunlight in a cool dry area.. Do not store your wet ODC SUPERSPORT XR1

result in Frame and other component damage.

7. Repairing Bladder, use enclosed patch kit. Identify puncture. Fully deflate Bladder. Clean and dry area around puncture.

Apply glue to puncture area and patch using applicator straw. Press patch over puncture area.

Allow 24 hours to dry, before inflating.

8. Note: Metal parts may rust and are not covered under warranty.

ODC SUPERSPORT XR 1

OUTDOOR DISCOVERY CRAFT

is designed to give you many years of service.

is guaranteed against defects in material and workmanship for the life of the

Air Bladders, outer skin and stitching for possible

without the Pontoons fully inflated.

is not designed for use in salt water.

CARE AND MAINTENANCE:

in direct sunlight.

View instructional video at www.creekcompany.com

Warning:

out in the sun for any amount of time, be aware that the heat can increase the

Accessories are available for your ODC SUPERSPORT XR 1

Ask for them where you bought your ODC SUPERSPORT XR 1™,

or visit the Creek Company Store at www.CreekCompany.com

Creek Company, PO Box 773892, Steamboat Springs, CO 80477

970-879-5221 • fax 970-879-7577 • email: [email protected]

Specifications and other details subject to change without notice.

is completely dry,deflated and stored

in freezing temperatures as this may

Made in China

PLEASE DO NOT