FHM SG24 Bedienings- en onderdelenhandleiding - Pagina 8

Blader online of download pdf Bedienings- en onderdelenhandleiding voor {categorie_naam} FHM SG24. FHM SG24 18 pagina's. Stump grinder

STUMP GRINDER SET-UP PROCEDURES

TRIMMING THE PTO SHAFT

The stump grinder is shipped with a PTO shaft that can be fitted to most tractors. The

PTO shaft may need to be trimmed depending on your tractor and configuration. Follow

the below steps to ensure that the PTO shaft is fitted to your tractor correctly.

1. Attach the stump grinder to the tractor, but do not install the PTO shaft.

2. Raise the stump grinder using the tractors 3 point hitch system so that the shaft on the

tractor is level with the shaft on the stump grinder.

3. Measure the distance between the locking grooves on the shaft of the tractor and

stump grinder (A) as shown below.

4. Measure the distance between the locking pins on the PTO shaft itself when it is in

the compressed/shortest length (B) as shown below.

5. If (A) is at least 1" longer than (B), the PTO shaft will not need to be cut.

6. If dimension (B) is longer than (A), the PTO shaft will need to be cut. The below

equation may be used to calculate the correct amount to trim.

7. Once (C) has been calculated; this amount will need to be cut off of BOTH halves of

the PTO shaft.

8. After both halves of the PTO shaft have been cut, use a file to remove any burrs or

sharp edges and slide the shaft together ensuring it telescopes in and out freely.

The PTO shaft can now be attached to the stump grinder and tractor, ready for use.

Farmer-HelperSG24 Stump Grinder

(B-A) + 1 INCH = C (AMOUNT TO CUT)

Revision 12-12-2017