Digikeijs DR4088OPTO Gebruiksaanwijzing - Pagina 6
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Digikeijs DR4088OPTO. Digikeijs DR4088OPTO 12 pagina's. Feedback module
Ook voor Digikeijs DR4088OPTO: Gebruiksaanwijzing (11 pagina's), Handmatig (8 pagina's), Gebruiksaanwijzing (14 pagina's), Gebruiksaanwijzing (15 pagina's)
Pagina afdrukken
DR4088CS / GND / OPTO
3.0 Programming
First, something fundamental about the S88(N) Bus®:
•
The S88(N)® bus is a universal bus system.
•
The S88(N)® bus supports a maximum of 256 feedback addresses.
•
The addresses are always assigned automatically and continuously. No universal and unique addressing is possible because the S88(N)® bus is not desig-
ned for individual address assignment!
•
The S88(N)® can only be set up as a bus (line) network. This always means from 1. feedback to 2. feedback, etc.
3.1 Programming DR4088xx (Assign start address in DR50xx)
The S88(N)® bus system does not provide programming in the actual sense. It only has to be defined in the central with which address the S88(N)® bus starts
and how many modules are located on the bus.
Programming the start address in the DR50xx
1.
Start the DR50xx tool.
2.
Call up the settings for the S88(N)® bus with the button in the ext88N tool.
3.
The start address and the number of modules must now be entered in this input mask.
www.digikeijs.com
® R-Bus, B-Bus are trademarks which are registered in the name of Modelleisenbahn GmbH. XpressNet and RS-Bus is a trademark registered in the name of Lenz
2021-08-11
P 6