Digilent chipKIT uC32 Referentiehandleiding - Pagina 5

Blader online of download pdf Referentiehandleiding voor {categorie_naam} Digilent chipKIT uC32. Digilent chipKIT uC32 18 pagina's.

chipKIT™ uC32™ Board Reference Manual

Jumper

POWER SELECT: Used to connect/bypass the on-board 5V regulator when using an

external power supply connected to J4.

JP2

J4 supply is regulated (i.e., 5V will be present

Note: To protect the PIC32 MCU, a 3.3V on-board regulator will always be enabled

regardless of JP2 settings.

Note: If you're not sure what POWER SELECT does, be safe and keep JP2 on the two right-

most pins so the J4 supply is regulated.

PWM/SPI SLAVE: Configures pin 10 on J5 to be used as a PWM output or a Slave Select

input for use as an SPI slave device.

JP4

SPI SELECT: Used to configure the chipKIT as either a Master or Slave when using the SPI.

The chipKIT board can be connected to another device or even another chipKIT through

the SPI connector (J8).

JP5/JP7

C/ANALOG PIN SELECT: Used to configure A4 and A5 for functionality as an analog input

or to be used as I

JP6/JP8

A4 and A5 on J7 are configured to be used

Other product and company names mentioned may be trademarks of their respective owners.

on 5V pin).

Pin 10 configured as an SPI SS input

chipKIT configured as an SPI master.

chipKIT configured as an SPI Slave

C communication pins.

as analog inputs.

Function

J4 supply bypasses regulator (i.e., Supply

voltage will be present on 5V pin).

Pin 10 configured as a PWM output

A4 and A5 are configured to be used as I

communication lines (A4 – SDA, A5 – SCL ).

Page 5 of 17