Digimerge DPD23D Gebruiksaanwijzing - Pagina 7
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Digimerge DPD23D. Digimerge DPD23D 15 pagina's. Ultra resolution day & night dome camera
Ook voor Digimerge DPD23D: Specificatie (2 pagina's), Gebruiksaanwijzing (15 pagina's), Gebruiksaanwijzing (14 pagina's)
Pagina afdrukken
INSTALLATION. INDOOR DOME
1
1a) Press down on the tab marked with an arrow to lift
1b) While pressing on tab, twist the dome cover
b
a
Method 1 - Direct Attach Install
2
2a) Use included mounting template to mark and pre-
a
Go to step
OR
Method 2 - Camera Base Install
Note: Use this method if installing onto junction box
2b) Remove the camera base by unscrewing the base
b
Note: If you plan on installing onto a junction box,
3
a
3a) Reinsert camera module into camera base
b
3b) Reinstall the base locking screws. (indicated by
Go to step
(Surface Fitting)
up the dome cover slightly
counter clockwise just a few degrees to release
dome cover from back clips.
Lift off the cover.
drill the required holes. Use included 2.8" screws
to mount the camera directly to the mounting
surface.
3
on page 9 to complete installation.
plate.
locking screws (indicated by padlock markings)
and turn camera module approx. 5 degrees
counter-clockwise to detach camera base from the
camera module. Install the base as indicated using
the 1.2" screws.
attach provided mounting plate first to the
junction box and then attach camera base
to the mounting plate.
by ligning up the arrow notches, and turning
camera module clockwise to lock into place.
padlock markings)
3
on page 9 to complete installation.
-8-
INSTALLATION. INDOOR DOME
1
1a) Press down on the tab marked with an arrow to lift
up the dome cover slightly
1b) While pressing on tab, twist the dome cover counter-
clockwise to release dome cover
1c) Remove the camera base by unscrewing the base
b
a
locking screws (indicated by a padlock markings)
and turn camera module approx. 5 degrees counter-
clockwise to detach camera base from the camera
module.
2
a) Cut semi flush mounting hole into surface using
provided flush mounting template.
Note: Always cut according to the inside of the cutout
template
b) Insert dome into cutout. Make sure that the
b
mounting arms are not extended.
c)
Turn screwdriver clockwise to unlock all of the 3
mounting arms.
d) Continue turning clockwise to move mounting arms
down until they make contact with inner mounting
surface.
d
c
Note: Once mounting arms have made contact with
a) Remove camera cover by squeezing the back and front
3
of the cover as indicated by the "PRESS" indicators at
the same time and lifting it up and away from the lens.
b) Insert the included video test cable into the RCA jack
and connect to a test monitor to set up camera. (see
page 10)
c)
Adjust camera viewing angle and secure into place by
tightening thumb screw using a flat head screwdriver.
Adjust lens and OSD as required.
Note: Lens adjustment levers are by default in the locked
position. Turn counter clockwise to unlock. Tighten
levers to secure lens setting.
a) Re-attach the camera cover, using the thumb screw as a guide, until it snaps into
4
place.
b) Reattach dome cover.
(Semi-Flush Fitting)
the inner mounting surface, do not apply too
much pressure to avoid damaging surface.
-9-