Cisco 3020 - Cisco Catalyst Blade Switch Aan de slag handleiding - Pagina 11

Blader online of download pdf Aan de slag handleiding voor {categorie_naam} Cisco 3020 - Cisco Catalyst Blade Switch. Cisco 3020 - Cisco Catalyst Blade Switch 37 pagina's. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Ook voor Cisco 3020 - Cisco Catalyst Blade Switch: Aan de slag handleiding (31 pagina's), Quickspecs (12 pagina's), Release Release (41 pagina's), Release Release (27 pagina's), Release Release (23 pagina's), Release Release (21 pagina's), Installatiehandleiding (21 pagina's)

Pagina afdrukken

Cisco 3020 - Cisco Catalyst Blade Switch Aan de slag handleiding

Using Express Setup to Assign a VLAN 1 IP Address to the Switch

Module

Use these steps to assign an IP address to the VLAN 1 interface through Express Setup. You must start

these steps immediately after you have installed the switch module (see the "Installing the Switch

Module in the Blade Server" section on page 6).

If approximately 2 minutes pass after you press the Mode button, obtaining the VLAN 1

Note

IP address through Express Setup is no longer possible unless you remove and then re-install

the switch module.

To prepare the switch module:

Step 1

Verify that no devices are connected to the switch module, because during Express Setup, the

switch module acts as a DHCP server. If your PC has a static IP address, before you begin you

should change your PC settings to temporarily use DHCP.

As the switch module powers on, it begins the power-on self-test (POST), a series of tests that

runs automatically to ensure that the switch module functions properly.

Wait for the switch module to complete POST. It might take several minutes for the switch

Step 2

module to complete POST.

Verify that POST has completed by confirming that the system and status LEDs remain green.

Step 3

If the switch module fails POST, the system LED turns amber. If the POST fails, see the "In

Case of Difficulty" section on page 21 to determine a course of action. POST errors are

usually fatal. Call Cisco Systems immediately if your switch module fails POST.