Resolved Caveats
CSCsb85001
•
When traffic passes through a VMPS port and you enter the shut interface configuration command,
a dynamic VLAN is now assigned.
CSCsc30733
•
This error message no longer appears during authentication when a method list is used and one of
the methods in the method list is removed:
AAA-3-BADMETHODERROR:Cannot process authentication method 218959117
CSCsd01180
•
The switch no longer reloads when you use a Kron command scheduler routine to automatically
copy configuration data using the Secure Copy Protocol (SCP). (Kron is a Cisco IOS utility for
scheduling non-prompting CLI commands to execute at a later time.)
CSCsd60718
•
When you enter the no speed interface configuration command, the Ethernet interface speed now
returns to its default setting.
CSCsd78044
•
When IGMP snooping is enabled and an EtherChannel member interface fails, the switch no longer
stops forwarding multicast traffic on the EtherChannel. In previous releases, this occurred when
multicast routing was enabled and the EtherChannel interface was a member of a multicast group not
directly connected (that is, the multicast group that did not have the C flag set in the show ip mroute
privileged EXEC command output).
CSCse14774
•
When a switch is connected to a third-party router through an EtherChannel and the EtherChannel
is running in Link Aggregation Control Protocol (LACP) mode, the interfaces in the EtherChannel
no longer fail after you enter the switchport trunk native vlan vlan-id interface configuration
command to change the native VLAN from VLAN 1 (the default) to a different VLAN ID.
•
CSCse33321
The Ethernet interface fastethernet0 no longer loses and regains its link because of a DHCP IP
address timeout. In previous releases, this situation existed when the HP Onboard Administrator
acted as the DHCP server and provided the IP address to this interface.
•
CSCsf98370
Fiber optic small form-factor pluggable (SFP) modules on the Catalyst Blade Switch 3020 for HP
now establish a link even when you configure the peer Ethernet interfaces with the speed
nonegotiate interface configuration command.
•
CSCsg18176
When dynamic ARP inspection is enabled and IP validation is disabled, the switch no longer drops
ARP requests that have a source address of 0.0.0.0. When you are enabling IP validation, use the
allow zeros keyword to allow the 0.0.0.0 source address.
•
CSCsg21537
When MAC addresses are learned on an EtherChannel port, the addresses are now correctly deleted
from the MAC address table.
•
CSCsg30295
When you configure an IP address on a switch virtual interface (SVI) with DCHP and enable DHCP
snooping on the SVI VLAN, the switch SVI can now obtain an IP address.
Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(44)SE
16
OL-14761-01
Pagina afdrukken