Cisco 3020 - Cisco Catalyst Blade Switch Installatiehandleiding - Pagina 11

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Cisco 3020 - Cisco Catalyst Blade Switch. Cisco 3020 - Cisco Catalyst Blade Switch 21 pagina's. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Ook voor Cisco 3020 - Cisco Catalyst Blade Switch: Aan de slag handleiding (37 pagina's), Aan de slag handleiding (31 pagina's), Quickspecs (12 pagina's), Release Release (41 pagina's), Release Release (27 pagina's), Release Release (23 pagina's), Release Release (21 pagina's)

Pagina afdrukken
Cisco 3020 - Cisco Catalyst Blade Switch Installatiehandleiding
Chapter 2
Switch Installation
Connect a straight-through Category 5 Ethernet cable (not provided) to any Ethernet port on the switch
Step 7
module front panel and to the Ethernet port on the PC. (See
Figure 2-6
Do not connect the switch module to any device other than the PC or workstation being used to
Caution
configure it.
Step 8
Connect the other end of the cable to the Ethernet port on the PC or workstation. Verify that the port
status LEDs on both connected Ethernet ports are green.
Step 9
Wait approximately 30 seconds after the port LEDs turn green, and launch a web browser on your PC or
workstation.
Enter the IP address 10.0.0.1 and press Enter.
Step 10
OL-8914-02
Connecting the Ethernet Cable from a PC to a Switch Module Ethernet Port
SY ST
STA T
DLX
17
UID
SP D
17x
MO DE
17x
CO NS
21x
OL E
WS -CB
20
S-3 020
17
-HP Q
18
19
23x
20x
20
24x
18x
24x
Figure
Cisco Catalyst Blade Switch 3020 for HP Hardware Installation Guide
Running Express Setup
2-6.)
2-11