Where to Go Next
Observe the port status LED.
Step 4
The LED turns green when the switch module and the target device have an established link.
The LED turns amber while the STP discovers the network topology and searches for loops. This process
takes about 30 seconds, and then the port LED turns green.
If the LED is off, the target device might not be turned on, there might be a cable problem, or there might
be a problem with the adapter installed in the target device. See
solutions to cabling problems.
Figure 2-14
If necessary, reconfigure and restart the switch module or target device.
Step 5
Where to Go Next
If the default configuration is satisfactory, the switch module does not need further configuration. You
can use any of these management options to change the default configuration:
•
•
•
Cisco Catalyst Blade Switch 3020 for HP Hardware Installation Guide
2-20
Installing an SFP Module
S Y S T
S T A T
17
D LX
U ID
S P D
M O D E
C O N S
W S -C B
O LE
S -3 02 0-
20
H P Q
1
Using the Device Manager
Access the device manager through a web browser from anywhere in your network. Follow
these steps:
Launch a web browser on your PC or workstation.
a.
Enter the switch module IP address in the web browser, and press Enter. The device manager
b.
page appears.
Use the device manager to perform basic switch module configuration and monitoring. Refer to
c.
the device manager online help for more information.
Using the Command-Line Interface
The switch module CLI is based on Cisco IOS software and enhanced to support desktop-switching
features. You can fully configure and monitor the switch module from the CLI. You can access the
CLI either by connecting your management station directly to the switch module console port or by
using Telnet from a remote management station. Refer to the switch module command reference on
Cisco.com for more information.
Using SNMP
You can use SNMP management applications such as CiscoWorks Small Network Management
Solution (SNMS) to configure and manage the switch module. You also can manage it from an
SNMP-compatible workstation that is running platforms such as HP OpenView or SunNet Manager.
17 x
17 x
21 x
17
18
19
20 x
20
24 x
18 x
Chapter 2
Switch Installation
Chapter 3, "Troubleshooting,"
23 x
24 x
for
OL-8914-02
Pagina afdrukken