Cisco 3750 - Catalyst EMI Switch Aan de slag handleiding - Pagina 23

Blader online of download pdf Aan de slag handleiding voor {categorie_naam} Cisco 3750 - Catalyst EMI Switch. Cisco 3750 - Catalyst EMI Switch 33 pagina's. Catalyst 3750 series switches
Ook voor Cisco 3750 - Catalyst EMI Switch: Gegevensblad (18 pagina's), Installatie Manuals (47 pagina's), Faq (10 pagina's), Product Bulletin (5 pagina's), Product ondersteunings bulletin (6 pagina's), Productoverzicht (25 pagina's), Beschrijving (1 pagina's), Gegevensblad (23 pagina's), Product ondersteunings bulletin (6 pagina's), Aan de slag handleiding (27 pagina's), Gegevensblad (23 pagina's)

• Did you wait 30 seconds after you connected

the switch and the PC before you entered the

IP address in your browser?

• Did you enter the wrong address in the

browser, or is there an error message?

Resetting the Switch

This section describes how to reset the switch by rerunning Express Setup. These are reasons why you

might want to reset the switch:

• You installed the switch in your network and cannot connect to it because you assigned the

incorrect IP address.

• You want to clear all configuration from the switch and assign a new IP address.

• You are trying to enter Express Setup mode, and the switch LEDs start blinking when you press

the Mode button (which means that the switch is already configured with IP information).

Caution

Resetting the switch deletes the configuration and reboots the switch.

To reset the switch:

• Press and hold the Mode button. The switch LEDs begin blinking after about 3 seconds. Continue

holding down the Mode button. The LEDs stop blinking after 7 more seconds, and then the switch

reboots.

The switch now behaves like an unconfigured switch. You can enter the switch IP information by using

Express Setup as described in the "Running Express Setup" section on page 4.

First look for a solution to your problem in the troubleshooting section of the Catalyst 3750 Hardware

Installation Guide or the Catalyst 3750 Software Configuration Guide on Cisco.com. You can also

access the Cisco Technical Support and Documentation website for a list of known hardware problems

and extensive troubleshooting documentation, including:

• Factory defaults and password recovery

• Recovery from corrupted or missing software

• Switch port problems

If not, wait 30 seconds, re-enter 10.0.0.1 in the

browser, and press Enter.

If yes, re-enter 10.0.0.1 in the browser, and press

Enter.