Cisco 9134 - MDS Multilayer Fabric Switch Hardware installatiehandleiding - Pagina 16

Blader online of download pdf Hardware installatiehandleiding voor {categorie_naam} Cisco 9134 - MDS Multilayer Fabric Switch. Cisco 9134 - MDS Multilayer Fabric Switch 36 pagina's. Mds 9000 series
Ook voor Cisco 9134 - MDS Multilayer Fabric Switch: Specificaties (3 pagina's), Configuratiehandleiding (49 pagina's), Release Release (48 pagina's), Release Release (44 pagina's), Release Release (22 pagina's), Release Release (3 pagina's), Release Release (40 pagina's), Release-opmerkingen (10 pagina's), Handmatig (16 pagina's)

Installing the Switch in a Cabinet with Insufficient Front Clearance

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Insert the switch into the rack:

Step 2

By using both hands, position the switch with the back of the switch between the rear rack-mounting

rails as shown in

Note

Figure 2-11

Align the two C brackets on either side of the switch with the slider rails installed in the rack. Slide

the C brackets onto the slider rails and then gently slide the switch all the way into the rack. If the

switch does not slide easily, try realigning the C brackets on the slider rails.

Stabilize the switch in the rack by attaching the front rack-mount brackets to the rear rack-mounting

Step 3

rails:

Insert two screws (12-24 or 10-32, depending on rack type) through the holes in one of the front

rack-mount brackets and into the threaded holes in the back rack-mounting rail (see

For racks with square holes, first install the 12-24 cage nuts.

Note

Cisco MDS 9100 Series Hardware Installation Guide

2-16

Figure

2-11.

Figure 2-11

shows the front rack-mount brackets in a 180 degree position. Your front

rack-mount brackets may look different if you kept them in the normal position.

Sliding the Cisco MDS 9100 Series Switch (Rear-Facing) onto the Slider Rails

Rear cabinet

mounting

rails

Figure 2-12

shows the front rack-mount brackets in 180 degree position. Your front rack-mount

brackets may look different if you kept them in the normal position.

Chapter 2

Installing the Cisco MDS 9100 Series

Front cabinet

mounting

rails

Figure

2-12.)

OL-21514-01