Upgrading Your Cisco MDS SAN-OS Software Image
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Table 7
Current Release with
FICON Enabled
SAN-OS 2.0(2b)
SAN-OS 1.x
Upgrading an MDS 9216 Switch with iSCSI Enabled
Following a software upgrade to Cisco SAN-OS Release 3.2(1) on a Cisco MDS 9216, 9216A, or 9216i
Switch, you need to enable iSCSI on all modules where iSCSI interfaces were present before the
upgrade. Use the iscsi enable module slot-number command to enable iSCSI, then issue the copy
running-config startup-config command to have the configuration take effect.
Upgrading with IVR Enabled
An Inter-Switch Link (ISL) flap resulting in fabric segmentation or a merge during or after an upgrade
from Cisco MDS SAN-OS Release 2.0(x) to a later image where IVR is enabled might be disruptive.
Some possible scenarios include the following:
•
•
•
If this problem occurs, syslogs indicate a failure and the flapped ISL could remain in a down state
because of a domain overlap.
This issue was resolved in Cisco SAN-OS Release 2.1(2b); therefore, you must upgrade to Release
2.1(2b) before upgrading to Release 3.2(1). An upgrade from Cisco SAN-OS Releases 2.1(1a), 2.1(1b),
or 2.1(2a) to Release 2.1(2b) when IVR is enabled requires that you follow the procedure below, and
Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Release 3.2(1)
16
FICON Nondisruptive Upgrade Path to SAN-OS 3.2(1)
Upgrade Path
Use the interface shutdown command to administratively shut any Fibre
Channel ports on Generation 1 modules that are in an operationally down
state before nondisruptively upgrading from SAN-OS Release 2.0(2b) to
SAN-OS Release 3.0(2) or SAN-OS Release 3.0(3b), and then upgrade to
Release 3.2(1). An operationally down state includes
not-connected, SFP not present
output of a show interface command. When an interface is
administratively shut it will then show as
Interfaces that are currently up or trunking do not need to be shut down.
Upgrade to SAN-OS Release 3.0(2). Use the interface shutdown
command to shut all the ports operationally down and administratively up
on all the Generation 1 modules before nondisruptively upgrading to
Release 2.0(2b) and then upgrade to 1.3(4a).
FCIP connection flapping during the upgrade process resulting in fabric segmentation or merge.
ISL flap results in fabric segmentation or merge because of hardware issues or a software bug.
ISL port becomes part of PCP results in fabric segmentation or merge because of a port flap.
Link failure or
, or
status in the
Error Disabled
Administratively down
.
OL-14116-01
Pagina afdrukken