Cisco ASR 920 series Handleiding installeren - Pagina 31
Blader online of download pdf Handleiding installeren voor {categorie_naam} Cisco ASR 920 series. Cisco ASR 920 series 36 pagina's. Aggregation services router
Ook voor Cisco ASR 920 series: Aan de slag (6 pagina's), Handleiding installeren (42 pagina's), Hardware installatiehandleiding (46 pagina's), Handmatig (36 pagina's)
Pagina afdrukken
Chapter 3
Installing the Cisco ASR 920 Series Router
Connect the DB-9 end of the console cable to the DB-9 end of the terminal.
Step 3
To communicate with the router, start a terminal emulator application, such as Microsoft Windows
Step 4
HyperTerminal. This software should be configured with the following parameters:
•
•
•
•
•
Connecting a Management Ethernet Cable
When using the Ethernet Management port in the default mode (speed-auto and duplex-auto) the port
operates in the auto-MDI/MDI-X mode. The port automatically provides the correct signal connectivity
through the Auto-MDI/MDI-X feature. The port automatically senses a crossover or straight-through
cable and adapts to it.
However, when the Ethernet Management port is configured to a fixed speed (10, 100, or 1000 Mbps)
through command-line interface (CLI) commands, the port is forced to the MDI mode.
When in a fixed-speed configuration and MDI mode:
•
•
To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety,
Warning
connect the Management Ethernet ports only to intra-building or unexposed wiring or cable. The
intrabuilding cable must be shielded and the shield must be grounded at both ends. The intra-building
port(s) of the equipment or subassembly must not be metallically connected to interfaces that connect
to the OSP or its wiring. These interfaces are designed for use as intra-building interfaces only (Type
2 or Type 4 ports as described in GR-1089-CORE) and require isolation from the exposed OSP cabling.
The addition of Primary Protectors is not sufficient protection in order to connect these interfaces
metallically to OSP wiring. Statement
Installing and Removing SFP and SFP+ Modules
The Cisco ASR 920 Series Router supports a variety of SFP and SFP+ modules, including optical and
Ethernet modules. For information on how to install and remove SFP and SFP+ modules, see the
documentation for the SFP or SFP+ module at:
http://www.cisco.com/en/US/partner/products/hw/modules/ps5455/prod_installation_guides_list.html
For information about inspecting and cleaning fiber-optic connections, see:
http://www.cisco.com/en/US/partner/tech/tk482/tk876/technologies_white_paper09186a0080254eba.s
html
OL-32751-01
9600 baud
8 data bits
no parity
1 stop-bit
no flow control
Use a crossover cable to connect to an MDI port
Use a straight-through cable to connect to an MDI-X port
Cisco ASR 920 Series Aggregation Services Router Hardware Installation Guide
Connecting a Cisco ASR 920 Series Router to the Network
3-31