Cisco ASR 920 series Handmatig - Pagina 17

Blader online of download pdf Handmatig voor {categorie_naam} Cisco ASR 920 series. Cisco ASR 920 series 36 pagina's. Aggregation services router
Ook voor Cisco ASR 920 series: Handleiding installeren (36 pagina's), Aan de slag (6 pagina's), Handleiding installeren (42 pagina's), Hardware installatiehandleiding (46 pagina's)

Installing the Cisco ASR 920 Series Router

This section provides procedures for installing and connecting SFP modules. Also, it provides the procedure

for removing SFP modules.

Install SFP Modules

The figure below shows an SFP module that has a bale-clasp latch.

Caution

We strongly recommend that you do not install or remove fiber-optic SFP modules with cables attached

because of the potential damage to the cables, the cable connector, or the optical interfaces in the SFP module.

Disconnect all cables before removing or installing an SFP module.

Removing and installing an SFP module can shorten its useful life. Do not remove and insert SFP modules

more often than is absolutely necessary.

Figure 17: SFP Module with a Bale-Clasp Latch

To insert an SFP module into the module slot, follow these steps:

SUMMARY STEPS

1. Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on the chassis.

2. If the SFP module that you are using has the markings, use them to identify the top side of the module.

3. Align the SFP module in front of the slot opening.

4. Insert the SFP module into the slot until you feel the connector on the module snap into place in the rear

of the slot.

5. Insert the cable connector into the SFP module:

DETAILED STEPS

Step 1

Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on the chassis.

Some SFP modules identify the top side of the module with send (TX) and receive (RX) markings or arrows that show

the direction of the connection.

Step 2

If the SFP module that you are using has the markings, use them to identify the top side of the module.

Step 3

Align the SFP module in front of the slot opening.

Step 4

Insert the SFP module into the slot until you feel the connector on the module snap into place in the rear of the slot.

Installing the Cisco ASR 920 Series Router

Install SFP Modules