Cisco BTS 10200 Gebruikershandleiding

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Cisco BTS 10200. Cisco BTS 10200 35 pagina's. Softswitch

Cisco BTS 10200 Softswitch

Cabling, VLAN, and IRDP Procedures

The purpose of this procedure is to explain how to:

•

This procedure is applicable to a Cisco BTS 10200 Softswitch with active and standby components

colocated in the same office.

This procedure is applicable only to systems with Continuous Computing hardware. If you are using

Note

other hardware, contact your Cisco account team for procedures.

This procedure is not applicable to Cisco BTS 10200 Softswitch systems that are already in service.

Do not use this procedure to change the cabling of an in-service Cisco BTS 10200 Softswitch, because

Caution

that will cause interruption of service. It is not necessary to change the cabling of in-service systems to

match this document.

Front View of Rack-Mounted Equipment

The front view of the standard Cisco BTS 10200 Softswitch system rack is shown in

Corporate Headquarters:

Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA

C I S C O C O N F I D E N T I A L

Cable a new Cisco BTS 10200 Softswitch system

Provision the virtual local area network (VLAN) on the Cisco 2924M Ethernet Switches (hubs)

Enable Internet Control Protocol (ICMP) Router Discovery Protocol (IRDP) functionality on the

Cisco BTS 10200 Softswitch and on the Cisco routers adjacent to the Cisco BTS 10200 Softswitch

Figure 1 on page