FIBARO SWIPE FGGC-001 Bedieningshandleiding - Pagina 8
Blader online of download pdf Bedieningshandleiding voor {categorie_naam} FIBARO SWIPE FGGC-001. FIBARO SWIPE FGGC-001 13 pagina's. Swipe gesture controller
Pagina afdrukken
14
#9: Powering modes
There are two powering modes of the Swipe. By default, powering
!
CAUTION
mode of the device is updated automatically (in intervals specified in
using batteries other
parameter 5) after changing type of supply.
than specified may re-
The Swipe sends detected gestures to the Z-Wave network
sult in explosion. Dis-
immediately, but configuration parameters and associations settings
pose of properly, ob-
only at wake up (in time intervals or manually), independently of the
serving environmental
powering mode.
protection rules.
Battery powering mode - by default, the Swipe is supplied with
4 batteries included with the device (type AA 1.5v). They are not
rechargeable and should be replaced after wearing out. The device in
i
this mode uses power saving function to preserve battery life.
NOTE
External supply mode - the Swipe can be supplied with a 5v DC
The device does not
power supply connected to the micro-uSB port. In this mode batteries
work as a Z-Wave
will work as an emergency supply.
repeater, even when
connected to the ex-
ternal power supply.
Power saving:
When battery powered, the Swipe will enter Standby Mode by default
(signalled with a low pitch beep) after 5 seconds of inactivity to reduce
the battery usage. In Standby Mode range and frequency of detection
are reduced preventing normal gesture detection. Operation of
power saving mode can be modified in parameter 6.
In order to exit Standby Mode:
1. Move your hand close to the centre of the pad.
2. Wait for the high pitch beep.
3. Move your hand away from the pad.
4. The device is ready to detect gestures.
POWERInG MODES
#10: Additional features
Service button B:
The Swipe is equipped with a service B-button, which allows to use
the menu. The B-button is located on back of the device and requires
dismounting the Swipe from its back case.
In order to operate the menu using the B-button:
1. Make sure the device is powered via micro-uSB port.
2. Press and hold the B-button.
3. Loud sound sequence will confirm entering the menu, keep
holding your hand.
4. Wait for the buzzer to indicate the desired menu position with short
beeps:
•
1 short beep (WhITE) - wake up the device
•
2 short beeps (GREEn) - learning mode (adding/removing)
•
3 short beeps (YELLOW) - the device reset
5. Release the B-button.
6. Click the B-button to confirm selection.
15
ADDITIOnAL FEATuRES