FIBER FOX Mini 6SI Gebruikershandleiding - Pagina 15
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} FIBER FOX Mini 6SI. FIBER FOX Mini 6SI 16 pagina's.
Pagina afdrukkenThere's dust or dirt on the fiber
surface
The lens or LEDs are coated in
dust
Cleaning Arc time is too short
It is difficult to identify the fiber
Dust Error
core by using the method of core
(fiber core)
alignment to splice
There's dust or dirt on the fiber
surface
There's dust or dirt on the fiber
surface
Cleave angle limit is too low
Overlap too much
Fat Fiber
Motor is not calibrated
Arc power too low
The level of pre-discharge is too
Thin Fiber
high
Insufficient overlap
Prepare the fiber again
Execute the dust check after
cleaning the lenses and LEDs
Set the cleaning arc time to be
180ms
It is difficult to identify the fiber
core by using MM splice mode to
splice
Prepare the fiber again
Execute the [Dust check] after the
lenses and LEDs are cleaned
Increase the cleave angle limit to
a decent value
(standard value: 3.0˚c)
Adjust overlap parameter
Calibrate and maintain the motor
Execute [Arc Calibration]
Decreased pre-discharge of
pre-discharge time
Adjust overlap parameter
- 28 -
Appendix III
[Questions and troubleshooting]
· Power does not turn off when pressing On / Off button.
Press and hold the key until the LED color changes from green to red.
· Few splices can be made with a fully charged battery pack
· If the power saving function is not enabled, battery power degrades quicker.
[System setting] Always enable it to conserve power usage.
· If degradation appears (memory effect). of if the battery pack is stored for an extended period of
time, complitely discharge it. After discharge completion, recharge the battery pack.
· The battery pack has reached the end of its service life. Install a new battery pack.
· The battery pack uses chemical reaction. The capacity decreases at low temperature, especially at
lower than 0 degree ˚c.
· Error message appears on monitor please refer to appendix II.
· Inconsistent splice loss / High splice loss
· Clean the V-grooves, fiber clamps, wind protector mirrors, and objective lenses.
· Replace the electrodes.
· Please refer to Appendix I.
· The splice loss varies according to the cleave angle, arc conditions and fiber cleanliness.
· Monitor suddenly turned off
· The monitor suddenly turn off after an extended period of splicer inactivity, if the power
saving function is enabled. Press any key to return to the normal state.
· Splicer power suddenly turned off without "Low battery' message.
· The monitor will turn off after an extended period of splicer inactivity, if the power saving
function is enabled. Press ant key to return to the normal state.
· Identify fibers error in AUTO mode
AUTO mode is applicable for SM, MM, NZ fiber. Errors may occurs while splicing special
fibers.
· Mismatch between Estimated splice loss and Actual splice loss
· The estimated loss is a calculated loss, so it can be used for reference only.
· The optical components of the splicer may need to be cleaned.
· Fiber protection sleeve does not shrink completely.
· Extend the heating time.
· Method to cancer heating process.
· Press Heat key to srop during heating process. The LED light will go off after pressing.
- 29 -