Sharp Carousel R-995E Bedieningshandleiding - Pagina 6
Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Sharp Carousel R-995E. Sharp Carousel R-995E 48 pagina's. Convection microwave oven
Pagina afdrukken
INSTALLATION INSTRUCTIONS
1. Remove all packing materials from the oven cavity. Check the unit for any damage, such as a misaligned
door, damaged gaskets around the door or dents inside the oven cavity or on the door. If there is any
damage, please do not operate the oven until it has been checked by a SERVICE CENTRE APPROVED
BY SHARP and repaired, if necessary.
2. Accessories provided
1) Turntable tray
2) Turntable support plate
3) Low rack
4) High rack
5) Defrost rack
6) Operation manual
7) Cook book
3. Since the door may become hot during cook-
ing, you should place or mount the oven so
that the bottom of the oven is 80 cm or more
above floor. You should also keep children
away from the door to prevent them burning
themselves.
4. Place the turntable support plate over the
turntable motor shaft on the floor of the cavity.
Then place the turntable on the turntable
support plate.
Make sure the turntable and support plate are centrally located and locked together. NEVER operate the
oven without the turntable support plate and turntable.
5. The oven should not be installed in any area where excessive heat and steam are generated, for example, next
to a conventional oven unit. When the oven is mounted on a kitchen benchtop, allow at least 40 cm on the top,
5 cm on both sides and at the rear of the oven for free air space. The ventilation openings should not be blocked.
6. Please consult your Sharp retailer for availability of built in kit. Before preparing kitchen cabinets for wall mounting,
please refer to the Sharp built in kit installation instructions for clearances and ventilation requirements.
7. Make sure that the power supply cord is undamaged, and that it does not run under the oven or over any
hot surfaces or sharp edges.
8. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or personal
injury for failure to observe the correct electrical connecting procedure.
The A.C. voltage must be single phase
9. Operate the oven from a general purpose domestic outlet.
If a generator is used, do not operate the oven with non-sinusoidal outputs.
10. Before using CONVECTION HEATER ELEMENTS for the first time, operate the oven without food for 20
minutes at 250 C. This will allow the oil that is used for rust protection to be burned off.
OVEN DIAGRAM
F
0
B
3
5
4
1. Oven lamp
2. Door hinges
3. Door safety latches
4. See through door
5. Door seals and sealing
surfaces
6. Touch Control Panel
7. Digital readout
• 230V-240V, 50Hz
8 1
A
9
3
8. Waveguide cover
9. Turntable motor shaft
10. Convection air openings
11. Menu Label for Intelligent Sensor
12. Rating label
13. Access cover for oven
lamp replacement
14. Ventilation openings
7
6
E
2
H
5
Turntable
Turntable
support plate
D
C
G
I
15. Power supply cord
16. Oven cavity
17. Outer cabinet
18. Low rack
19. High rack
20. Defrost rack
J