DIGISYSTEM AFV2000-2,5A Gebruiksaanwijzing - Pagina 9

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} DIGISYSTEM AFV2000-2,5A. DIGISYSTEM AFV2000-2,5A 9 pagina's. For variable frequency vibrators

Pagina afdrukken
REFERENCE
PIN NUMBER
REF. CURR.
REF. VOLT.
POT
CCW
CW
0V
RUN
INV. OK
+18V
If voltage reference is coming from potentiometer 10K located on front panel, the
switch SW3 (yellow) must be ON (lever up);
The power supply is delivered with this switch on.
If voltage reference is coming from external voltage generator, the switch SW3 (yellow)
must be OFF (lever down) connect 0V at pin 6 and reference at pin 8.
If voltage reference is coming from external potentiometer 10K, the switch SW3
(yellow) must be OFF (lever down), the potentiometer sliding contact must be connected to
pin 8, the CW to pin 5 and the CCW to pin 6.
A switch (SW2 red) on front panel selects automatic or remote start/stop; the switch
ON selects start at power-on, the switch OFF enables start from external command. The
power supply is delivered with this switch ON.
The start-stop control with one external sensor (photocell or other type of sensor) is
available a supply (18 V 50 mA not stabilized).
PNP Sensor: connect supply of sensor between pins 1 (
sensor at pin 3.
NPN Sensor: connect supply of sensor between pins 1 (
sensor at pin 3 and change position of jumper H4 from P to N; H4 is located inside the box,
see opening instructions.
Inverter OK: for remote check of the power supply is available a PNP (18V 20mA) signal
at pin 2; pin 4 is 0V.
OPTIONS WIRING TABLE (M2)
WIRE
SECTION
mmq
9
0,35
8
0,35
7
0,35
6
0,35
5
0,35
4
0,35
3
0,35
2
0,35
1
0,35
SIGNAL DESCRIPTION
Current reference (0-20mA)
Voltage reference (0-5V)
Potentiometer sliding contact
Potentiometer counterclockwise side
Potentiometer clockwise side (+5V insulated)
0V insulated for external sensor feeding
Run command from PNP or NPN sensor
Power supply is OK
+18V insulated for external sensor feeding
) and 4 (
+18V
) and 4 (
+18V
9
), connect signal of
0V
), connect signal of
0V