Sharp CD-DH899N Bedieningshandleiding - Pagina 5
Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Sharp CD-DH899N. Sharp CD-DH899N 17 pagina's. Sony car speaker user manual
Pagina afdrukken
Listening to the iPod
Supported iPod models:
● iPod nano (software 1.2 above)
● iPod mini (software 1.2 above)
th
● iPod (5
generation) (software 1.3 above) (Dock connector equipped
Click Wheel model)
● iPod (4
th
generation) (software 3.0.2 above) (Dock connector
equipped Click Wheel model)
nd
● iPod nano (2
generation) (software 1.0.0 above)
● iPod nano (3
rd
generation) (software 1.0.3 above)
● iPod nano (4
th
generation) (software 1.0.3 above)
● iPod classic (software 1.0.3 above)
● iPod touch (software 1.1 above)
nd
● iPod touch (2
generation) (software 2.1 above)
Caution:
Please update your iPod unit to the latest software version from Apple's
homepage before using it.
iPod adaptor connection
Notes:
● iPhone is not supported by this system.
● You can use an audio cable to connect your iPod to the AUDIO IN
jack if:
1.
your iPod adaptor does not fit into the iPod dock on the main unit.
2.
you have an iPod that does not have an iPod adaptor.
3.
you have an iPod that does not have an iPod 30 pin connector.
To insert iPod adaptor
1
Press the ON/STAND-BY button to turn the power on.
2
Insert the iPod adaptor into the iPod dock and connect your iPod.
iPod (bottom)
Dock connector
iPod adaptor
(not supplied)
iPod dock
iPod connector
iPod playback
1
Press the ON/STAND-BY button to turn the power on.
2
Press the iPod button on the remote control or FUNCTION button
repeatedly on the main unit to select iPod function.
3
Insert iPod unit in iPod dock of main unit.
4
Press the
/ button to start playback.
Notes:
● Once the iPod is connected to the unit it will begin charging.
● The iPod unit cannot be charged while the main unit is in the stand-
by mode or during USB mode.
● Please make sure to set iPod unit to either NTSC or PAL to match
your TV signal. Please visit Apple's homepage for further information.
To remove iPod adaptor
Insert the tip of a screwdriver ("–" type, small) into the iPod adaptor hole
as shown and lift upward to remove.
iPod
To disconnect iPod
Simply remove the iPod from the iPod dock. It is safe to do so even during
playback.
Navigating the iPod menus
1
Press the MENU button to view the menu on iPod unit. Press it
again to go back to previous menu.
2
Use the TUNING (
an item on the menu and then press ENTER button.
Note:
When navigating the iPod menus with remote control, do not operate any
of the buttons on the iPod unit. The volume level is adjusted by pressing
the VOL (+ or –) button on the main unit or the remote control. Adjusting
the volume on the iPod unit gives no effect.
iPod operation:
The operations described below depend on the generation iPod you are
using.
System on operation:
When the main unit is powered on, the iPod unit will automatically power
on when docked in the unit (including TIMER function/exclude USB
function).
System off (stand-by operation):
When the main unit is turned to stand-by mode, the docked iPod unit will
automatically turn to stand-by mode.
E-4
M INI CO M PO NENT S YSTEM
CD-DH899
POWER
ON/STAND-BY
POWER
ON/STAND-BY
CD
USB
TAPE
or
) button on the remote control to select
FUNCTION
VOL