Sharp AL-2021 Handleiding starten - Pagina 6

Blader online of download pdf Handleiding starten voor {categorie_naam} Sharp AL-2021. Sharp AL-2021 45 pagina's. Digital multifunctional system
Ook voor Sharp AL-2021: Handleiding starten (41 pagina's)

Pagina afdrukken

CAUTIONS

Caution label on the unit

The label (

) in the fusing area of the unit indicates the following:

: Caution, risk of danger

: Caution, hot surface

Cautions on using

Follow the cautions below when using this unit.

Warning:

• The fusing area is hot. Exercise care in this area when removing misfed

paper.

• Do not look directly at the light source. Doing so may damage your eyes.

• Unit power must be turned off before installing any supplies.

Caution:

• Place the unit on a firm, level surface.

• Do not install the unit in a humid or dusty location.

• When the unit is not used for a long time, for example during prolonged

holidays, turn the power switch off and remove the power cord from the

outlet.

• When moving the unit, be sure to turn the power switch off and remove the

power cord from the outlet.

• Do not switch the unit rapidly on and off. After turning the unit off, wait 10

to 15 seconds before turning it back on.

• Do not cover the unit with a dust cover, cloth or plastic film while the power

is on. Doing so may prevent heat radiation, damaging the unit.

• Use of controls or adjustments or performance of procedures other than

those specified herein may result in hazardous radiation exposure.

• The socket-outlet shall be installed near the unit and shall be easily

accessible.

Important points when selecting an installation site

Do not install your unit in areas that are:

• damp, humid, or very dusty

• exposed to direct sunlight

• poorly ventilated

• subject to extreme temperature or humidity changes, e.g., near an air

conditioner or heater.

Be sure to allow the required space

around the unit for servicing and

proper ventilation.

Cautions on handling

Be careful in handling the unit as

follows to maintain the performance of

this unit.

Do not drop the unit, subject it to shock or strike it against any object.

Do not expose the drum cartridge to direct sunlight.

• Doing so will damage the surface (green portion) of the drum cartridge,

causing smudges on copies.

Store spare supplies such as drum cartridges and TD cartridges in a

dark place without removing from the package before use.

• If they are exposed to direct sunlight, smudges on copies may result.

Do not touch the surface (green portion) of the drum cartridge.

• Doing so will damage the surface of the cartridge, causing smudges on

copies.

CAUTION:

Do not install the machine in a location with poor air circulation.

A small amount of ozone is created inside the machine during printing.

The amount of ozone created is not sufficient to be harmful; however, an

unpleasant odor may be noticed during large copy runs, and thus the

machine should be installed in a room with a ventilation fan or windows

that provide sufficient air circulation. (The odor may occasionally cause

headaches.)

* Install the machine so that people are not directly exposed to exhaust

from the machine. If installed near a window, ensure that the machine is

not exposed to direct sunlight.

Supply and Consumables

The supply of spare parts for a repair of the appliance is guaranteed for at

least 7 years following the termination of production. Spare parts are

those parts of the apparatus which may break down within the scope of

ordinary use of the product, whereas those parts which normally exceed

the life of the product are not considered spare parts. Consumables also,

are available for 7 years following the termination of production.

20 cm

10 cm

In some areas, the "POWER" switch positions are marked "I" and " " on

the copier instead of "ON" and "OFF".

If your copier is so marked, please read "I" for "ON" and " " for "OFF".

Caution!

For a complete electrical disconnection, pull out the main plug.

The socket-outlet shall be installed near the equipment and shall

be easily accessible.

Shielded interface cables must be used with this equipment to maintain

compliance with EMC regulations.

Laser information

780 nm+15 nm

Wave length

-10 nm

Pulse times

12.88 µs ±12.88 ns/7 mm

Output power

Max 0.2 mW

At the production line, the output power of the scanner unit is adjusted to

0.18 MILLIWATT PLUS 5% and is maintained constant by the operation of

the Automatic Power Control (APC).

Caution

Use of controls or adjustments or performance of procedures other than

those specified herein may result in hazardous radiation exposure.

This Digital Equipment is CLASS 1 LASER PRODUCT (IEC 60825-1

Edition 1.2-2001)

This product is designed for commercial application only and as such it falls

outside the scope of Regulation (EC) 1275/2008 implementing EU

Directive 2005/32/EC on eco-design requirements for standby and off

mode electric power consumption. Sharp does not recommend the product

for domestic application and will not accept any liability for such use.

Products that have earned the ENERGY STAR

designed to protect the environment through superior

energy efficiency.

The products that meet the ENERGY STAR

shown above.

The products without the logo may not meet the ENERGY STAR

SOFTWARE LICENSE

The SOFTWARE LICENSE will appear when you install the software from

the CD-ROM. By using all or any portion of the software on the CD-ROM or

in the unit, you are agreeing to be bound by the terms of the SOFTWARE

LICENSE.

Trademark acknowledgements

• Microsoft

, Windows

Windows 7

and Internet Explorer

trademarks of Microsoft Corporation in the U.S.A. and other countries.

• Adobe

, the Adobe

logo, Acrobat

are registered trademarks or trademarks of Adobe Systems Incorporated

in the United States and other countries.

• IBM, PC/AT, and PowerPC are trademarks of International Business

Machines Corporation.

• Sharpdesk is a trademark of Sharp Corporation.

• All other trademarks and copyrights are the property of their respective

owners.

Do not make copies of anything which is prohibited from copying by law.

The following items are normally prohibited from copying by national

law. Other items may be prohibited by local law.

Money

Stamps

Bank drafts

Checks

Emission density (measured according to RALUZ122: Edition

Jun.2006)

Measured

Condition of

chemicals

copier

Ozone

Dust

When copier is in

Styrene

operation

Benzene

TVOC

When on standby

are

guidelines carry the logo

guidelines.

2000, Windows

XP, Windows Vista

are registered trademarks or

, the Adobe

PDF logo, and Reader

Bonds

Stocks

Passports

Driver's licences

Colour mode

Diffusion speed

Black and white

1.5 gm/h or less

Black and white

4.0 gm/h or less

Black and white

1.0 gm/h or less

Black and white

0.05 gm/h or less

Black and white

10 gm/h or less

2.0 gm/h or less