Sharp AR-M550N Gebruikershandleiding - Pagina 16

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Sharp AR-M550N. Sharp AR-M550N 20 pagina's. Digital multifunctional system

Pagina afdrukken

PROGRAMS FOR COPY MODE

This chapter explains the key operator programs that are used for copy mode.

Copy settings

"Copy settings" consists of the following programs:

G Initial status settings

G Exposure adjustment

G Rotation copy setting

G Add or change extra preset ratios

G Initial margin shift setting

G Erase width adjustment

G Card shot settings

G Initial tab copy setting

G Setting a maximum number of copies

G Disabling deletion of job programs

G Disabling of bypass-tray in duplex copy

G Disabling of auto paper selection

*1 Default settings selected with these programs apply

to all functions of the machine (not just the copy

function).

Initial status settings

The copy settings revert to the default settings when

the power switch is turned on, when the [CA] key is

pressed, or when the auto clear time elapses. This

program is used to change the default settings, or

return changed default settings to the initial factory

default settings.

Defaults for the following copy settings can be

changed:

Paper tray/Exposure tray/Copy ratio/2-sided copy/Out

put (sort/non-sort, staple sort/non-staple, output tray)

NOTE

If this program is used to change the default setting

for the duplex function to other than "one-sided"

"one-sided" and the automatic document feeder fails

or is disabled, the setting will revert to "one-sided"

"one-sided".

* DISABLING OF DOCUMENT FEEDER (page 11)

DISABLING OF DUPLEX (page 11)

Exposure adjustment

This program is used to adjust the exposure level when

"Auto" is used for the copy exposure.

The factory setting is "5". "1" indicates lighter density

and "9" indicates darker density on the touch panel.

Rotation copy setting

If this program is set, the image of originals will rotate

when the orientation of the originals does not match

that of the copy paper.

(Rotation copy will function only if the auto paper select

or auto image mode has been selected.)

NOTE

For copying from A5 or 5-1/2" x 8-1/2" size originals

onto A5R or 5-1/2" x 8-1/2"R paper, this program

must be set.

Add or change extra preset ratios

When using AB sizes, there are normally five preset

enlargement ratios and five preset reduction ratios.

When using inch sizes, there are normally four preset

enlargement ratios and four preset reduction ratios.

This program allows you to add two more preset

enlargement ratios and two more preset reduction ratios.

This program also allows you to change a preset ratio.

NOTE

Only an added preset ratio can be changed.

Initial margin shift setting

This program is used to set the initial margin shift

amount.

The initial margin shift amount can be set from 0 mm to

20 mm (0" to 1") in increments of 1 mm (1/8").

Normally the margin shift is set to 10 mm (1/2") for both

the front and back of the paper.

Erase width adjustment

This program is used to set the initial width of edge

erase copying.

The edge erase width can be set from 0 mm to 20 mm

(0" to 1") in increments of 1 mm (1/8").

The edge erase and center erase widths are normally

set to 10 mm (1/2").

Card shot settings

This program is used to set the initial original size for

the card shot function.

Enter the X dimension (width) first and then the Y

dimension (length).

Both the X and Y dimensions can be set from 25 mm to

210 mm (1" to 8-1/2") in increments of 1 mm (1/8").