Sharp AR-NB3 Handleiding voor afdrukken - Pagina 32

Blader online of download pdf Handleiding voor afdrukken voor {categorie_naam} Sharp AR-NB3. Sharp AR-NB3 41 pagina's. Digital copier/printer/multifunctional system option
Ook voor Sharp AR-NB3: Werking netwerkscanner (40 pagina's), Opties Handleiding (44 pagina's)

Pagina afdrukken

KEY OPERATOR PROGRAMS

The key operator programs allow the administrator of the machine (key operator) to enable and disable functions to

suit the needs of the workplace. This chapter explains the key operator programs for the network and printer

functions. For key operator programs for general use of the machine, see the "Key operator's guide".

For the initial key operator code set at the factory, see "PROGRAMMING A KEY OPERATOR CODE" in the "Key

operator's guide".

KEY OPERATOR PROGRAM LIST

The key operator programs for the network and printer functions are shown in the following table. Factory default

settings are indicated in bold. When "YES, NO" appears in the "Settings" column of a program, the program is

enabled by pressing the [OK] key so that a checkmark appears in the checkbox. A checkmark in the checkbox (

indicates that "YES" is selected. No checkmark (

The key operator programs that can be accessed depend on the machine and the options that are installed.

Note

Mode

NETWORK

ENABLE DHCP

IP ADDRESS SETTINGS

• IP ADDRESS

• SUBNETMASK

• DEFAULT GATEWAY

ENABLE TCP/IP

ENABLE NetWare

ENABLE EtherTalk

ENABLE NetBEUI

PRINTER

NOTICE PAGE

FORCED OUTPUT OF

OUTPUT TRAYS

Program

YES, NO

–

YES, NO

CENTER TRAY,

UPPER TRAY

) indicates that "NO" is selected.

Settings

Enable this setting if the machine will use an

IP address that is assigned by a DHCP server.

If DHCP is used, the IP address assigned to

the machine may change automatically on

occasion. If this happens, printing will not be

possible. Change the port setting of the printer

driver to the new IP address.

If the machine will be assigned a permanent

IP address, use these settings to enter the IP

address, subnet mask, and default gateway.

SPECIAL SETTINGS (page 33)

Select whether or not TCP/IP protocol will be used.

Select whether or not NetWare protocol will

be used.

Select whether or not EtherTalk protocol will

be used.

Select whether or not NetBEUI protocol will

be used.

Select whether or not a Notice Page

36)

is printed when printing is not successful

due to a memory full (or other) error.

When no tray has the specified size of paper,

this setting is used to select whether or not

the print job will be printed on the closest size

of paper.

Specifies the output tray. When the printer

driver is used to print, the setting in the printer

driver has priority. (This setting is only

available if a job separator tray is installed.)

Explanation

(page

)