Sharp AR-P450 Handmatig bijvullen - Pagina 7
Blader online of download pdf Handmatig bijvullen voor {categorie_naam} Sharp AR-P450. Sharp AR-P450 8 pagina's.
CAUTION
If a cartridge is to be discarded, dispose of it according to local requirements.
Store toner cartridges out of the reach of children.
NOTE
Do not shake the toner cartridge after the sealing tape has been removed. If the cartridge is shaken after the tape is
removed, some toner will come out of the cartridge.
For recycling of used toner cartridges, see the information included with the cartridges.
Maintenance
When maintenance is required, a message indicating it will appear. When this message appears, contact your
authorized SHARP service center.
Required in IEC-950 (EN 60 950) - Europe
• The equipment should be installed near an accessible socket outlet for easy disconnection.
Required in Appendix ZB of BS 7002 (En 60 950) — United Kingdom
The mains lead of this equipment is already fitted with a mains plug which is either a non-rewireable
(moulded) or a rewireable type. Should the fuse need to be replaced, a BSI or ASTA approved fuse
to BS1362 marked
be used.
Always refit the fuse cover after replacing the fuse on the moulded plug. Never use the plug without
the fuse cover fitted.
In the unlikely event of the socket outlet in your home not being compatible with the plug supplied
either cut-off the moulded plug (if this type is fitted) or remove by undoing the screws if a rewireable
plug is fitted and fit an appropriate type observing the wiring code below.
DANGER: The fuse should be removed from the cut-off plug and the plug destroyed immediately
and disposed of in a safe manner. Under no circumstances should the cut-off plug be inserted
elsewhere into a 13A socket outlet as a serious electric shock may occur.
To fit an appropriate plug to the mains lead, follow the instructions below:
IMPORTANT: The wires in this mains lead are coloured in accordance with the following code:
As the colours of the wires in this mains lead may not correspond with coloured markings
identifying the terminals in your plug, proceed as follows:
The wire which is coloured GREEN-AND YELLOW must be connected to the terminal in the plug
which is marked with the letter E, or by the safety earth symbol Å@, or coloured green or green-
and-yellow.
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter
N or coloured black.
The wire which is coloured BROWN must be connected to the terminal which is marked with the
letter L or coloured red.
If you have any doubt, consult a qualified electrician.
WARNING: THIS APPARATUS MUST BE EARTHED.
MAINS PLUG WIRING INSTRUCTIONS
or
and of the same rating as the one removed from the plug must
GREEN-AND-YELLOW:
BLUE:
BROWN:
Earth
Neutral
Live