Digital Acoustics IP7-FD Aan de slag handleiding - Pagina 2

Blader online of download pdf Aan de slag handleiding voor {categorie_naam} Digital Acoustics IP7-FD. Digital Acoustics IP7-FD 4 pagina's.

Pagina afdrukken

IP7-FD Installation

For 2-way Intercom Audio

No Connection

Microphone

Talk

Speaker

Relay Output (optional)

Sensor Input (optional)

J1 / J2 / J3 Connector Interface

Microphone

Talk Button

Optional

12VDC - 15VDC*

Cat-5 Cable

to PoE

Hub/Switch

Use 18-20 AWG

Twisted Shielded

2 Conductor in

Use 18 AWG for all

separate jacket

for Microphone

other connections

Door Sensor (optional)

Door Strike (optional)

Speaker

Relay Options

• The integrated Relay uses COMMON (J3-2), along with NO - Normally

Open (J3-1) or NC - Normally Closed (J3-3). Use Admin Console to

configure the options

Sensor Options

• The integrated Sensor can be used to monitor the status of a door by

connecting Sensor (J3-5) and GND (J3-6) to a contact closure sense

switch. Use Admin Console to configure the options

Power Options

• Power over Ethernet (PoE - 802.3af compliant) - requires 15.4 Watts from

Power Source Equipment (PSE)

• 12VDC at 15 watts via J1-1 and J1-2 connectors (polarity independent)

• 12VDC at 15 watts via the Aux Power 2.1mm barrel connector

• An external power supply, if detected, overrides PoE power

Network Installation

• Connect an RJ-45 cable between the Ethernet 10/100 connector and a

network switch

• After the Ethernet 10/100 is connected, another IP device can be

connected to Port 2 10/100 jack

Mounting Instructions

The IP7 series is design to be mounted on standard 35mm DIN rail or

surface mounted using the surface mounting plate

• DIN Rail Clip – Tilt top of unit (J1, J2, J3 connectors facing up with Volume

buttons facing forward) back towards the DIN Rail until the IP7 DIN clip

catches the top of the rail. Press in at the bottom of the IP7 to snap into

place

• Surface Mount Plate – Snap the surface mount plate in half and secure it

to the back of the unit using the provided screws so that the mounting

holes extend past the edges of the case

Page 2 of 4