Sharp AN-PH30EZ Installatiehandleiding - Pagina 2

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Sharp AN-PH30EZ. Sharp AN-PH30EZ 2 pagina's. Standard zoom lens for projector
Ook voor Sharp AN-PH30EZ: Bedieningshandleiding (16 pagina's), Bedieningshandleiding (16 pagina's), Bedieningshandleiding (15 pagina's)

Pagina afdrukken

Remove the lens mounting

screws.

Lens mounting screws

Rotate the replacement lens 90

degrees in the direction shown

by the arrow (1 1 1 1 1 ), align the posi-

tioning pin with the guide hole

(2 2 2 2 2 ), tighten the lens mounting

screws and then connect the

cable connector (3 3 3 3 3 ).

Positioning pin

Cable connector

Guide

hole

Pull out the lens towards you and

then take out the lens (2 2 2 2 2 ) by ro-

tating it 90 degrees (1 1 1 1 1 ) in the di-

rection shown by the arrow.

(When the lens being attached is the AN-

PH30EZ (XG-PH50X standard lens))

Attach the lens ring.

• Align the a mark on the lens ring with the

positioning pin on the lens (silver pin), in-

sert the lens ring all the way to the back

and then rotate in the direction of the ar-

row.

Positioning pin

a mark

Remove the lens cap (on the

back) from the replacement lens.

• This explanation uses the example of the

AN-PH10EX.

Positioning pin

Lens cap (back)

Attach the lens cover.

• Insert the lens cover while spreading apart

the ring section (made of rubber), and then

attach the tabs to the ribs.

Ribs

Tabs

Lens cover

Insert the replacement lens into

the lens mount with the motor

section facing up.

Lens mount

Motor section

Connect the cable connector by

following steps 1 through 3, and

then attach the top cover and

lamp unit cover.

• The power of the projector will not come

on unless the lamp unit cover is securely

attached.

Printed in China

TINS-B760WJZZ

05P01-CH-NM