Sharp Conference Series XG-PH80W-N Installatiehandleiding - Pagina 28
Blader online of download pdf Installatiehandleiding voor {categorie_naam} Sharp Conference Series XG-PH80W-N. Sharp Conference Series XG-PH80W-N 32 pagina's. Projectors
Ook voor Sharp Conference Series XG-PH80W-N: Brochure & specificaties (4 pagina's), Specificatieblad (4 pagina's), Specificaties (2 pagina's)
Pagina afdrukken
Troubleshooting
Communication cannot be established with the projector
When connecting the projector using serial-connection
Check that the RS-232C terminal of the projector and a computer or the commercially
available controller are connected correctly.
Check that the RS-232C cable is a cross-over cable.
Check that the RS-232C port setting for the projector corresponds to the setting for the
computer or the commercially available controller.
When connecting the projector to a computer using network (LAN)-
connection
Check that the cable's connector is fi rmly inserted in the LAN terminal of the projector.
Check that the cable is fi rmly inserted into a LAN port for a computer or a network device
such as a hub.
Check that the LAN cable is a Category 5 cable.
Check that the LAN cable is a cross-over cable when connecting the projector to a computer
directly.
Check that the LAN cable is a straight-through cable when connecting the projector with a
network device such as a hub.
Check that the power supply is turned on for the network device such as a hub between the
projector and a computer.
Check the network settings for the computer and the projector
Check the following network settings for the projector.
•
•
•
•
•
-28
IP Address
Check that the IP address for the projector is not duplicated on the network.
Subnet Mask
When the gateway setting for the projector is "0.0.0.0" (Not Used), or the gateway setting
for the projector and the default gateway setting for the computer are the same:
•
The subnet masks for the projector and the computer should be the same.
•
The IP address parts shown by the subnet mask for the projector and the computer
should be the same.
(Example)
When the IP address is "192.168.150.2" and the subnet mask is "255.255.255.0" for the
projector, the IP address for the computer should be "192.168.150.X" (X=3-254) and the
subnet mask should be "255.255.255.0".
Gateway
When the gateway setting for the projector is "0.0.0.0" (Not Used), or the gateway setting
for the projector and the default gateway setting for the computer are the same:
•
The subnets for the projector and the computer should be the same.
•
The IP address parts shown by the subnet mask for the projector and the computer
should be the same.
(Example)
When the IP address is "192.168.150.2" and the subnet mask is "255.255.255.0" for the
projector, the IP address for the computer should be "192.168.150.X" (X=3-254) and the
subnet mask should be "255.255.255.0".
Note
When "DHCP Client" is set to "Off" on the projector:
IP address: 192.168.150.2
Subnet mask: 255.255.255.0
Gateway address: 0.0.0.0 (Not Used)
For network settings for the projector, refer to pages 22-23.