Shimano DENDOUMARU 4000HP Gebruiksaanwijzing - Pagina 9

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Shimano DENDOUMARU 4000HP. Shimano DENDOUMARU 4000HP 32 pagina's.

Shimano DENDOUMARU 4000HP Gebruiksaanwijzing
Learning Method
1
When winding line other than Shimano Antares 50lbs.-600m
(use Learning mode).
S L S
Beep
Press once
1
Switch on the clutch lever.
Then check power connection.
When the mode-switch is pressed
once with something that looks like a
ball pen, "学習 (Learning)" will be
displayed, and you are in Learning mode.
If you press the mode-switch more than
twice, it will turn into Specify mode or
Down-winding mode. To return to Learn-
ing mode again, you have to press a few
more times.
(The actual figure of the line used will be memorized in the reel)
2
Press the Main switch, and wind the line.
The RPM will be displayed.
Line tension is shown at left-bottom,
adjust till you get figure 3.
(Using a wet towel apply tension and
wind the line. Do not apply tension
with bare hands. Doing so can result
in injury. )
The figure shows the tension of winding-
up line, and expressed in figure. The
figure is not equal to kg.
Indicates
revolution
(RPM)
IMPORTANT:
The up-winding tension
should be 3.
Note: Counter value error will
become large when tension is not
accurately matched during learning.
Winding speed can be adjusted with speed
button.
When you want to stop the winding, press the
main switch one more time.
When the remaining line is short, the line end
(above drawing) should not be wound in. Be
careful here. If necessary, use your hand to wind.
If the end is wound, correct input becomes
impossible to get.
When the line remaining is short,
be careful not to let the line-end goes
right in.
Continue to Next Page
9