Digital Barriers EDGEVIS VIDEO ROUTER 4 Hardware installatiehandleiding - Pagina 2
Blader online of download pdf Hardware installatiehandleiding voor {categorie_naam} Digital Barriers EDGEVIS VIDEO ROUTER 4. Digital Barriers EDGEVIS VIDEO ROUTER 4 16 pagina's.
Pagina afdrukken
EDGEVIS VIDEO ROUTER HARDWARE INSTALLATION
Introduction
Before proceeding with the installation and setup of your EdgeVis Video Router, please ensure that you have read and
understood the Safety Notes. Check that the package contents match that listed below, refer to the installation notes
on the next page and consult the Quick Start Guide that was supplied with your unit for step-by-step instructions on
preparing hardware and software components.
To operate the EdgeVis Video Router you will need to set up, or have access to, the following architecture:
EdgeVis Video Router
To proceed you must have access to an EdgeVis Server, with an account created for the encoder to use. If you do not
have an EdgeVis Server available refer to EdgeVis Server Quick Start Guide which will walk through the steps
required to install the server and create the necessary accounts required to proceed.
A note on naming: This guide occasionally refers to the EdgeVis Video Router device as an encoder – this is how
EdgeVis Server refers to all video recording/transmission devices.
What is in the box?
1x EdgeVis Video Router, supplied with universal mounting bracket
1x
Power, with cable
1x Quick Start User Guide
2x Cellular antennae
How do I configure the EdgeVis Video Router?
After the introduction, there are three sections in this document that help you to configure your EdgeVis Video Router:
Section 1
Section 2
Section 3
Appendix A
Appendix B
Appendix C
ISSUED: 29 NOVEMBER 2022
sends video to
EdgeVis Server
Basic operations
Configuring communications
Next steps...
Troubleshooting and frequently asked questions
Approved Accessories
Compliance Statements
sends video to
EdgeVis Clients
PAGE 2