Crestron FlipTop FT2 Series Snelstarthandleiding - Pagina 2

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Crestron FlipTop FT2 Series. Crestron FlipTop FT2 Series 11 pagina's. Ac power outlet modules
Ook voor Crestron FlipTop FT2 Series: Snel aan de slag (2 pagina's), Snel aan de slag (2 pagina's), Snelstarthandleiding (11 pagina's), Snelstarthandleiding (2 pagina's), Snelstarthandleiding (9 pagina's), Snelstarthandleiding (9 pagina's), Snelstarthandleiding (11 pagina's), Aan de slag (2 pagina's), Aan de slag (2 pagina's), Aan de slag (2 pagina's), Handmatig (2 pagina's), Handmatig (2 pagina's), Handmatig (2 pagina's), Snelstarthandleiding (7 pagina's), Snelstarthandleiding (8 pagina's), Snel aan de slag (2 pagina's), Snelstarthandleiding (2 pagina's), Snel aan de slag (2 pagina's), Snel aan de slag (2 pagina's), Snelstarthandleiding (2 pagina's), Snel aan de slag (2 pagina's), Snel aan de slag (2 pagina's)

FT2-500-ELEC-PTL

FlipTop™ FT2 Series Cable Management System, 500 Size, Electrical, Pass-Through Lid

Mount the FlipTop Assembly

A mounting hole is required for an FT2-500-ELEC-PTL installation. Use

the included template to cut a mounting hole for new installations.

When determining the location for the FT2 assembly, consider where

users will be seated and their proximity to the FT2 assembly's modules

and retractors. Refer to the

FT2A-CBLR-1T

cable retractors for above-the-table cable pull-out lengths.

Cut the Mounting Hole

A saw and the included cutout template are required to cut the

mounting hole.

1. Check the table surface and the area beneath the table. Clear any

obstructions that may impede the installation or functionality of the

FT2 assembly, retractors, and accessories.

2. Using the included cutout template, trace an outline of the mounting

hole onto the table.

3. Cut the mounting hole in the table with an appropriate saw.

and

FT2A-CBLR-GR

series

Secure the FlipTop Assembly

To prepare the FT2-500-ELEC-PTL and secure it to the table surface:

1. Gently remove the bezel before securing the FT2 assembly to the

table. It is held in place with magnets.

2. Locate the included DC power splitter cable.

Quick Start