Actron 615 Gebruikershandleiding - Pagina 7

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Actron 615. Actron 615 8 pagina's. Engine analyzer

Pagina afdrukken
AMPS
TEST
(ALTERNATOR
OUTPUT)
SLIDE SWITCH KNOB
TO "AMPS" POSITION
The alternator output should be checked if the volt-
age reading was below 13.8 in the CHARGING
SYSTEM TEST on page 5, or if the battery requires
frequent charging with a portable charger.
Set the slide switch knob to AMPS.
The Function
Selector Knob can be at any position.
Observe
the test reading on the 0-160 AMPS scale.
1. Consult the vehicle service manual for the
correct method of disconnecting the regulator in
order to check the alternator output without the
regulator in the circuit.
When the regulator is —
disconnected, the circuit must be bypassed
in
order to observe alternator output.
Consult the
vehicle service manual for correct method of
bypassing the regulator circuit.
2. Remove the Negative cable connection on the
battery.
This will eliminate the danger of shorting
the battery with the tool used to perform Step 3.
3. Consult the service manual for the vehicle
being tested for the location of the alternator
output terminal and remove the cable from the
output terminal.
Connect the shunt between
N
SNe
y
Ñ
;
\
:
a r
c a
\
ALTERNATOR
OUTPUT
\\ CABLE
NN
the cable and terminal as shown.
Be sure these
connections are tight.
The slotted side of the
shunt should be connected to the Positive terminal
on the alternator.
Reconnect the Negative cable
to the battery.
6