Crestron Electronics CSMI-QMTDC Series Snelstarthandleiding - Pagina 7
Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Crestron Electronics CSMI-QMTDC Series. Crestron Electronics CSMI-QMTDC Series 9 pagina's. Replacement motor
Pagina afdrukken
CSM(I)-QMTDC Series Motor Replacement
Replacement Motor
3. Once all devices have been acquired, take the gateway out of Acquire
mode. Refer to the gateway's manual for details.
Leaving an infiNET EX Network
To leave an infiNET EX network, put the device into Acquire mode, as
described in
Joining an infiNET EX Network
mode.
Verifying Communications Status
To check the communications status of the device, tap the SET button
three times and then press and hold it down (tap-tap-tap-press+hold) for
up to 2 seconds. The LED flashes to indicate the communications status.
Refer to the following table for details.
LED
Turns on for 5
The device is communicating with the control system.
seconds
Flashes twice
The device was previously joined to the network but is not
communicating with the gateway.
Flashes once
The device is not joined to the network.
when no gateway is in Acquire
Communications Status
LED Diagnostics
The LED flashes to provide a visual reference that the motor is operating
normally or if it is in an error state.
Normal Operation
The following table provides a list of possible LED patterns encountered
during normal operation. All LEDs extinguish after 1 minute of inactivity if
there are no errors to report.
LED Patterns
LED Pattern
Two fast flashes, then pause
(1/8-second on, 1/8-second off,
1/8-second on, 5/8-second off)
Slow flash (1/2-second on, 1/2-second
off)
Solid
Fast flash (1/4-second on, 1/4-second
off)
Slow flash (1/2-second on, 1/2-second
off)
Solid
Slow flash (1/2-second on, 1/2-second
off)
Quick Start
LED
Operating Mode
Color
Blue
A firmware upgrade over
the Cresnet® network is
in progress.
Blue
The motor's internal
firmware upgrade is in
progress.
Blue
The motor is in
Bootloader mode.
White
The motor is in Identify
mode.
Green
The motor is moving
from a local button
press.
Green
The motor is
communicating with the
control system program.
Red
The motor is not
communicating with the
control system.
7