Digital Data Communications LevelOne GTL-2091 Handmatig - Pagina 6
Blader online of download pdf Handmatig voor {categorie_naam} Digital Data Communications LevelOne GTL-2091. Digital Data Communications LevelOne GTL-2091 8 pagina's. Attack prevention configuration
Ook voor Digital Data Communications LevelOne GTL-2091: Handmatig (4 pagina's)
Pagina afdrukkenChapter 2 Setting the IPv6 Services
2.1 Setting the IPv6 Services
After IPv6 is enabled, all services provided by IPv6 can be set. The configurable
IPv6 service is shown below:
(1)
Managing the IPv6 Link
2.1.1 Managing the IPv6 Link
IPv6 provides a series of services to control and manage the IPv6 link. This series
of services includes:
(1)
Setting the transmission frequency of the ICMPv6 packet
(2)
Setting the source IPv6 route
(3)
Setting the MTU of IPv6
(4)
Setting IPv6 redirection
(5)
Setting IPv6 destination unreachablity
(6)
Setting IPv6 ACL
(7)
Setting IPv6 Hop-Limit
1. Setting the transmission frequency of the ICMPv6 packet
If you want to limit the transmission frequency of the ICMPv6 packet, run the command in
the following table. If the ICMPv6 transmission frequency is larger than the set value, the
transmission frequency will be limited.
The default transmission frequency is 1000us. If you want to modify the transmission
frequency, run the following command in global mode:
Command
ipv6 icmp6-ratelimit ratelimit
2. Setting the source IPv6 route
IPv6 allows a host to designate the route of an IPv6 network, that is, the source route.
The host can realize the source route through using the routing header in the IPv6
http://www.level1.com
IPv6 Configuration
Purpose
Sets the transmission
frequency of the ICMPv6
packet.
- 3 -