Digital Electronics /PS-3711A Series Installatiehandleiding

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Digital Electronics /PS-3711A Series. Digital Electronics /PS-3711A Series 8 pagina's. Ssd unit
Ook voor Digital Electronics /PS-3711A Series: Installatiehandleiding (13 pagina's)

Pagina afdrukken

PS-3710A/PS-3711A Series

Hard Disk/SSD Unit

Installation Guide

This installation guide covers the following

products.

• PS371XA-HD60P

• PS371XA-SD16P

The PS371XA-HD60P is the hard disk unit

(HDD unit) for Pro-face's PS-3710A/PS-

3711A Series.

The PS371XA-SD16P is the SSD unit for

Pro-face's PS-3710A/PS-3711A Series.

This HDD/SSD unit has built-in recording

device to be used for loading the IDE I/F of

the PS-A

Corresponding units:

PS-3710A/PS-3711A Series

(hereafter referred as the "PS-A")

About the Manual

For the detailed information on PS-A series,

refer to the following manuals.

• PS-3710A/PS-3711A Series Hardware

Manual

Manuals can be downloaded from Pro-face

Home Page.

URL

http://www.pro-face.com/otasuke/

Safety Cautions

• Be sure to check that the PS-A unit's

power is disconnected before installing

the unit, in order to prevent an electri-

cal shock.

• Do not attempt to modify or open the

HDD/SSD unit, since it can cause a

shock or fire.

• When installing the HDD/SSD unit, be

sure to read this guide "Installation"

section's information completely to

insure that the unit is correctly

installed.

To Prevent Accidents

• Since the HDD/SSD unit is a precision

instrument, be sure it is neither hit by nor

pressed strongly against another object.

After unpacking, be sure the unit is not

dropped or jolted during installation. Also,

a PS-A unit built in to a larger unit (i.e.

operation panel) should be removed and

packed separately prior to shipping.

• Be sure water, liquids or metal particles are

not allowed to enter the HDD/SSD unit.

Any of these may cause either a break-

down or an electrical shock.

• Do not place or store this unit in a location

where there is direct sunlight, excessive

heat, dust or vibration.

• Do not store or operate this unit near chem-

icals, or where there are chemical fumes.

• Do not allow anyone other than Pro-face's

own service staff to perform maintenance

or adjustments to this unit.

• Do not move or shift the PS-A unit while

the HDD/SSD unit is installed and the PS-

A unit's power is ON.

• Do not use the HDD/SSD unit in locations

where corrosive gasses are present, since

they can lead to a hard disk breakdown.

• To prevent the data damage, be sure to shut

down the PS-A unit's OS according to the

correct procedure before turning OFF the

main power.

• To prevent memory leaks, restart the OS

periodically.

• The hard disk has the lifetime. To use it

longer by steady operation, read the

attached "Instructions for Using the Hard

Disk" carefully.