Digital Equipment TLZ07 Installatiehandleiding - Pagina 8

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Digital Equipment TLZ07. Digital Equipment TLZ07 16 pagina's. Tape drive for dec 4000 model 6x0/7x0 axp series

TLZ07
Remove any SCSI ID cables from the OCP connector on the bezel
assembly.
Loosen the two captive screws that secure the mounting bracket to the
chassis.
Pull on the mounting assembly until it slides away from the chassis.
Place the mounting assembly on the antistatic pad.
2. Connect the SCSI ID cable to the back of the drive (Figure 1).
3. Slide the drive into the mounting assembly.
4. Attach the SCSI and power cables to the drive. Figure 1 shows the location
of the connectors.
5. Secure the drive into the mounting assembly with the four mounting
screws provided. Two screws attach to the top of the assembly, and two
screws attach to the bottom of the assembly (Figure 3 shows the top of the
assembly). Make sure that the top front screw goes through the grounding
strip shown in the figure.
Failure to connect the grounding strip could result in data errors.
6. Remove the blank panel from the bezel (Figure 4).
7. Remove the blank flat plug(s) from the bezel (Figure 5).
8. Return the OCP connector board to the bezel.
9. Install SCSI ID plugs on the front of the bezel. Each drive must have an
unique SCSI ID number. Make sure that the drive that was installed prior
to this add-on procedure retains the same SCSI ID number that was used
previously. The front of the bezel is marked to show the corresponding
SCSI ID plug for each slot.
10. Slide the mounting bracket assembly into the option storage slot and push
until the SCSI paddle card on the drive mounting bracket engages securely
into the backplane. Secure the drive by tightening the two captive screws.
Figure 2 shows the location of one of the screws. The second screw is
located on the bottom drive mounting bracket. Do not over-tighten the
screws; 9" lbs is sufficient to secure the drive. It is normal for there to be a
slight gap between the bracket and chassis.
6
Caution