Siemens SIMATIC ET 200S Handmatig - Pagina 16

Blader online of download pdf Handmatig voor {categorie_naam} Siemens SIMATIC ET 200S. Siemens SIMATIC ET 200S 28 pagina's. Distributed i/o digital electronic module 4do dc24v/2a hf
Ook voor Siemens SIMATIC ET 200S: Gebruikershandleiding (18 pagina's), Handmatig (16 pagina's), Gebruikershandleiding (16 pagina's), Gebruikershandleiding (26 pagina's), Handmatig (37 pagina's), Handmatig (24 pagina's), Functiehandboek (40 pagina's), Gebruiksaanwijzing (4 pagina's), Originele gebruiksaanwijzing (19 pagina's), Originele gebruiksaanwijzing (20 pagina's), Handmatig (34 pagina's), Handmatig (14 pagina's), Handmatig (24 pagina's), Originele gebruiksaanwijzing (17 pagina's), Originele gebruiksaanwijzing (19 pagina's), Handmatig (16 pagina's), Handmatig (28 pagina's), Handmatig (12 pagina's), Handmatig (32 pagina's), Handmatig (18 pagina's), Handmatig (12 pagina's), Handmatig (22 pagina's), Handmatig (22 pagina's), Handmatig (36 pagina's), Handmatig (16 pagina's)

Pagina afdrukken
Siemens SIMATIC ET 200S Handmatig
Diagnostics

3.2 Channel-related diagnostics - error types

3.2
Channel-related diagnostics - error types
Analog input module error types
Table 3-1
31
D
22
D
16
D
9
D
8
D
7
D
6
D
16
Error types
Error type
11111: Channel
The firmware is being updated.
temporarily
Channel 0 applies to the entire
unavailable
module. The module does not
perform any measurements
during this time.
10110: Hardware
A hardware interrupt was not
interrupt lost
recognized.
10000: Parameter
Module cannot utilize the
assignment error
parameters for the channel:
Inserted module does not
match the configuration.
Incorrect parameter
assignment.
01001: Error
Internal module error
(diagnostic message at
channel 0 applies to the entire
module)
01000: Low limit
Value is below the underrange. Correct the module/actuator
exceeded
00111: High limit
Value is above the overrange.
exceeded
00110:
Line to the encoder is
Open circuit
interrupted.
Meaning
2AI I 2WIRE HS analog electronic module (6ES7134-4GB52-0AB0)
Remedy
--
Correction or coordination of
the program, process, module
Correct the configuration (align
actual and preset configuration).
Correct the parameter
assignment (wire break
diagnostics assigned only for
the allowed measuring ranges).
Replace the module.
tuning.
Correct the module/actuator
tuning.
Correct the process wiring.
Manual, 01/2008, A5E01001734-02