Siemens SIPART PS2 Installatie-instructie kit - Pagina 7

Blader online of download pdf Installatie-instructie kit voor {categorie_naam} Siemens SIPART PS2. Siemens SIPART PS2 9 pagina's. Mounting bracket kit
Ook voor Siemens SIPART PS2: Installatie-instructie (4 pagina's), Gebruiksaanwijzing (28 pagina's), Installatie-instructie (4 pagina's), Hardware installatiehandleiding (30 pagina's), Technische beschrijving (26 pagina's), Compacte gebruiksaanwijzing (35 pagina's), Installatie-instructie (11 pagina's)

7. If "NOINI" is flashing on display, skip to step 12, otherwise go to step 8. A typical configuration

mode display is shown in Figure 9.

8. Press and hold [HAND] button to enter configuration mode. When display changes, release

button. See Figure 10.

Slip Clutch

Thumbwheel

9. Press and release [HAND] button until parameter 4 is displayed in lower left corner of display.

10. Press and hold [-] minus button until "no" appears on display.

11. Press and hold [HAND] button to exit configuration mode. When display changes, release button.

12. Using [+] plus and/or [-] minus buttons move valve throughout valve travel. While moving the valve

with the pushbuttons, ensure that:

The feedback linkage does not prevent the valve from fully stroking. Adjust as needed.

The feedback pin moves freely within the feedback lever for the entire valve travel.

All hardware is tightened securely.

Note: To move quickly in one direction press and hold [+] plus button then [-] minus button. To

move quickly in the opposite direction reverse button sequence.

13. Use a [+] or [-] button to move the valve to a position away from an end-stop. Verify that the valve

remains at that position once buttons are released; if it moves check for air leaks.

FIGURE 7 Sample PS2 Configuration Mode Display

HAND

Button

FIGURE 8 Set-up Buttons (PS2 Cover Removed)

(Minus)

+ (Plus)

Button

15900-796

Transmission gear

ratio switch set to 33